When you sandblast something like this or an engine you gotta make sure you clean the part extremly well afterwards. A few particles of sand can destroy a transmission or an engine. Also never hammer a new bearing onto a shaft use an arbor press or even a vise.
For some strange reasons sand blasting and through that removing dead and old paint of any component/part is highly SATISFYING, who all agree with me 🙏
Not that I'm defending him, but those transmission's are pretty bulletproof and looked to be in very nice shape so a rebuild most likely wasn't needed and the cleanup he did was great! Restoration no, but don't forget the language barrier. Good enough for a thumbs up from me.
بسم الله الرحمن الرحيم والحمد الله رب العالمين سبحان الله وبحمده سبحان الله العظيم ولا حول ولا قوة إلا بالله العلي العظيم وأتوب إليه وأشهد أن لا ألله إلا الله وأشهد أن محمد رسول ألله
.. نتائج البحث نتيجة الترجمة العربية الإنجليزية shukraan jadhyla lak ya akhy aleizyz atmny lak alsaeadat waltawafyq min eamalik almubaraka Thank you very much, dear brother. I wish you happiness and success from your blessed work
That is great you restore every Toyota Camry car part. Your Toyota Camry runs like new again. You should work for Toyota restoring Toyota Camry's like new.
Hola.que la barrera del idioma no sea un impedimento que buen trabajo,bendiciones sigue así,espero que termines pronto y sin ningún contratiempo ese proyecto,Saludos desde Armenia Colombia ☺❤👍✌🌟🌟🌟🌟🌟
For all the Would be restorers and rebuilders out there, Camrys are Front Wheel drive Vehicles. That gearbox is from a rear wheel drive vehicle. There are those for whom rear wheel drive vehicles are different from front wheel drive vehicles. Applies in every country. Additionally, rebuilds of mechanical equipment customarily entail slightly different procedures to those displayed in this Utube video. just my two bits worth.
StrayCat that's right. But! It has to be gasket material and NOT printer paper which they used. I watch this video through my 85" television and you can clearly see it is regular paper.
If you use muriatic acid mixed with water, the use a hard bristle brush it will clean aluminum really fast. I washed aluminum truck trailers are turned out great😁👍
Hello! Just got my 2011 Crown Victoria Police Interceptor (with a 4 speed automatic transmission) rebuilt. Is there a certain amount of time that I have to break it in and drive it lightly until I can floor it? Your response is much appreciated!
New bearings, new synchros, check all gears for wear, adjust shifter linkage -- That's a restoration. Hard work, and requires a ton of know-how.
clean- yes restore-no
Only clean and paint
totally ageree
restoration is another thing..
I thinks so
What kind of sealing is this colorfull thing? :D
I love the last gasket made from a Disneyland magazine paper.
Oh, I didn't see any restoration, I saw a cleaning and washing.
A lot of increased longevity can be had from a thorough disassembly and a good cleaning. Well done guys.
А если помыть не разберая, тоже самое получиться?.
Before you start disassembling---pressure wash the dirt off the equipment---.
Of course
When you sandblast something like this or an engine you gotta make sure you clean the part extremly well afterwards. A few particles of sand can destroy a transmission or an engine. Also never hammer a new bearing onto a shaft use an arbor press or even a vise.
For some strange reasons sand blasting and through that removing dead and old paint of any component/part is highly SATISFYING, who all agree with me 🙏
Not that I'm defending him, but those transmission's are pretty bulletproof and looked to be in very nice shape so a rebuild most likely wasn't needed and the cleanup he did was great! Restoration no, but don't forget the language barrier. Good enough for a thumbs up from me.
The hatchet: an essential part of every mechanics arsenal.
Soon available on EBay as a fully “restored” 4speed. Didn’t appear to be rebuilt though. I guess there a difference.
c5back9 exactly correct. I was thinking the same thing. Love the printer paper cut out for gasket. Wish I thought of that. Lol!!!
so, you just cleaned and painted it?
Вот так попадают запчасти в Россию под видом новые😆
بسم الله الرحمن الرحيم والحمد الله رب العالمين سبحان الله وبحمده سبحان الله العظيم ولا حول ولا قوة إلا بالله العلي العظيم وأتوب إليه وأشهد أن لا ألله إلا الله وأشهد أن محمد رسول ألله
What’s with to coloful gasket? Also, no torque specs.? Nice paint job tough, even on the surface where the gaskets go.
And........he just take it apart... to clean it!
18:50 broke the thread
11:09 did you just paint machined surfaces.
They might as well flip them over and paint the inside while they’re at it
I was waiting for the mainshaft to get a coat next.
Title is wrong. Should read, How to wash a gearbox in flip-flops
Nice cleaning video, now you need to learn the basics of rebuilding which took me about two years under the guidance of a seasoned mechanic.
tim mayer. Yes agree, The first step, clean the dam thing first. Wow. two years? Are you a slow learner? lol
Ни сальники , ни синхронизаторы, ни подшипники даже не дефектовались ))))
Смысл разбирать ? Чтобы потом просто покрасить? ))))
И полтора ляма просмотров)) Даже в названии не исправили на 5 ступку! Втулку в кулисе также не меняли. Забили половой орган на всё.
У меня такая коробка и я ждал замену синхронизаторов. У меня вторая плохо втыкается
Excelente trabajo me gusta la mecánica saludo desde Nicaragua
هدا العمل ممتاز وجد ممتاز ، شكرا علي الإتقان في العمل ، بعد التنظيف والتصلبح تكون بحالة جيدة .....
thank you
Nice Buff and Polish .
Next time I'm in Vietnam I gotta find guys like you to hang out with.
Restoration ❌
Cleaning ✅
복원에 달인 이시네요.~^^
..
نتائج البحث
نتيجة الترجمة
العربية
الإنجليزية
shukraan jadhyla lak ya akhy aleizyz atmny lak alsaeadat waltawafyq min eamalik almubaraka
Thank you very much, dear brother. I wish you happiness and success from your blessed work
That is great you restore every Toyota Camry car part. Your Toyota Camry runs like new again. You should work for Toyota restoring Toyota Camry's like new.
Hola.que la barrera del idioma no sea un impedimento que buen trabajo,bendiciones sigue así,espero que termines pronto y sin ningún contratiempo ese proyecto,Saludos desde Armenia Colombia ☺❤👍✌🌟🌟🌟🌟🌟
Rwd Camry? Latin market only?
Có súng phun cát làm nhàn vậy
トヨタ系のポルシェタイプのM/Tに見えますが
ただバラして掃除してるだけで
ベアリングやオイルシールは、交換しないんですかねえ？
@14:15 the screw on the left holding the wheel grinder down to the table is unscrewing as you are cleaning the bolts. Might wanna secure that better.
By reading comments then there’s no point of continueing to watch..
I wish I did. I was like "oh finally, they're gonna take off the old sync- um, why are they putting it back together?"
Very nice work. Sandblaster included.
For all the Would be restorers and rebuilders out there, Camrys are Front Wheel drive Vehicles. That gearbox is from a rear wheel drive vehicle. There are those for whom rear wheel drive vehicles are different from front wheel drive vehicles. Applies in every country. Additionally, rebuilds of mechanical equipment customarily entail slightly different procedures to those displayed in this Utube video. just my two bits worth.
Nice to see you haven't forgotten the camry, I was a little worried there for some time. 💯💯💯
Thank you for watching our videos
@@restoration-restore-repair My pleasure. I will always support the people in SEA they are the most friendly and welcoming ones
@@rogerraven6976 thank you
А замена подшипников не нужно да?
Ótimo trabalho
Ótimo vídeo
Um grande abraço
Balveer return
I thank you with all my heart for this achievement👌🏽👌🏽👌🏽👌🏽
Great video hate smell of gear oil
Wow Amazing work, satisfying to watch,❤ Keep it up.
Good work
Good job. I prefer explanations rather than musics or songs
Please guys uploade more videos 0n car restoration, you do a great job
is that gas they use to clean the metal parts?
very common in south east asia
Este video , hizo que me suscribiera , trabajaron exelente con esa caja de cambios , Felicitaciones aquien lo hizo.
Good cleaning
Good job. But this is not restore. This is cleaning and painting.
Dengan tangan yang luar biasa, berakhir menjadi baru kembali.👍👍👍
Is this transmission for sale?
بہت اچھا لگا معلومات میں اضافہ ہوا ♥️♥️♥️👍👍
Is the gasket cut out of plain paper? Прокладка вырезана из обычной бумаги?))))
you make gaskets from gasket sheets for custom applications or for no longer made gaskets
StrayCat that's right. But! It has to be gasket material and NOT printer paper which they used. I watch this video through my 85" television and you can clearly see it is regular paper.
The one trick NAPA doesn't want you to know about.
Этот коробас хоть 100 км проехал после такого "ремонта"? 😁
What water or fluid did u use??
What acid you used to clean
А чего мультиметром не потыкал в шестерни?
подъипал :D
Смысл ее разбора? Если даже профилактики не было.
Nice job Bloke !. thanks for posting.
Это финиш. Не одной новой детали! От того что вы ее отмыли, износ не ушел!!
Please tell me this gearbox model name and details.
And please make from this gearbox changing synchronise and berings
Can you tell me what gearbox this is??
What exactly did you fix?
What liquid did you use to clean the Gear Box? And does it hurt the parts
Nice to see you peter
what gun do you use for cleaning
what liquid do you use for cleaning
Saludos desde costa Rica
This is not a restoration, it is just dismantled, washed, painted.
Please use a torque wrench. An impact wrench into alloy is too dangerous.
Nice work
This is not a restoration, it is called just cleaning and painting!!!!!
It's just cleaning and painting bro. Anyways good job 👍
Примерно так у нас в магазах востановленные запчасти продают.
Ну похоже не только у нас ))))
If you use muriatic acid mixed with water, the use a hard bristle brush it will clean aluminum really fast. I washed aluminum truck trailers are turned out great😁👍
Car TOYOTA... very good and nice work
That looks really nice guys.
если это реставрация кпп то, как будет выглядеть реставрация двигателя тоже разобрал помыл и обратно собрал.
Есть у него такое видео про двигло от мотоблока) он там даже кольца поменял и прокладки из бумаги тоже там используются)
Прокладки из бумаги - годнота!)))
What is the liquid you used to degrease everything?
Diesel I'd wager.
Cover the thread and sealing area before painting
More of a We took apart a transmission cleaned it up painted it and put it back together
Great video. What was that substance you use to clean the parts?
Only gasoline works that well.
Y q paso con la restauración. No se arregló nada ,. Oh fue limpieza o.k
Primary go to tool: Hatchet. No synchros while it’s that far apart?
no... big hammer with hatchet app..
great work
thanks
Great job
What material clean almunium gear box
please make more of these videos on the toyota this is awesome
Hello! Just got my 2011 Crown Victoria Police Interceptor (with a 4 speed automatic transmission) rebuilt. Is there a certain amount of time that I have to break it in and drive it lightly until I can floor it? Your response is much appreciated!
احب اعرف هل تم اكمال العجله،، لاتوجد مقاطع فديو لاكمال العجله ارجو منكم الرداوالاجابه علىسؤالي تحياتي
Sempre digo isso aos meus filhos.
Интересно, это на каком поколении Toyota Camry ДВС и, соответственно, МКПП стояли продольно?? да и вообще размеры этой МКПП ...
Это коробка серии W, она ставилась на Маркообразные
Nice boys, just like magic.
Good job ! Buen trabajo ! Y en tu idioma no lo sé jeje
what kind of liquid can you use
I think it's diesel
Những chỗ mặt phẳng vỏ hộp số với lỗ gắn bi mấy bác lại phun cát với phun sơn lên thì cũng bó tay.
good job i like it
whats the name of the air-preassured gun cleanliness you are using for the exterior ?
Sand blaster
Curious.. is that water your using to clean, or just paint tiner
Gasoline is my guess.
very good
عاشت ايدك على هدا عمل حلوه