2D Drawing to 3D CAD - PRACTICE MODEL- Exercises for Onshape, SolidWorks - BASE EXTENDER

[@stevejessen7523]

Stuffed up the first attempt, but started again for 9:35 in Onshape and the right answer of 0.284 lbs.
How easy is it when the ribs don't finish on a cylinder??!

[@TooTallToby]

lol - totally a game changer when they just run into a nice flat surface that fully terminates the rib "up to next" :-)

[@ninadsbhatt100]

Mass = 0.29 pounds, 33:30:85, SW.

[@TooTallToby]

awww yeah well done!

[@airwavested]

0.2844 lb Fusion 18:33 min

[@TooTallToby]

Nice!

[@Benutzername0000]

.284 in 15:02 SW

[@TooTallToby]

Awww yeah nice job - correct answer is always shown at the end of the video :-)

[@JoyceHuang-ce3ri]

In the top view, how do you know where to start the arc?

[@SolidworkSina]

0.284 lbs @14:40 SW

[@TooTallToby]

awww yeah - well done!

[@Shuroro]

.2840 lbs in 12:40 in solidworks

[@TooTallToby]

Awww yea well done!

[@BobPhelpsRRIowa]

SW @ 14 min. .2839 pounds. This one was tough for me. Had to start over because I didn't have a good plan of attack.

[@TooTallToby]

yeah always good to have that game plan!

[@robwilliamson441]

9:52 Onshape

[@TooTallToby]

Well done!

[@DesignDreamer-d1q5n]

I've done it before, but still took 20 min. .284 in Solidworks.

[@TooTallToby]

yeah this is a fun one!

[@tomlaionyt]

.282lb
11:30min
Plasticity
redone 0.284lb

[@TooTallToby]

Nice job ! I like the Redone time!

[@gerry1611]

.2857 in 10 minutes using solidworks

[@TooTallToby]

Awww yeah!

[@TrainDriverRob]

0.284 lbs, still taking me 15 minutes, I like to think before tackling the drawing

[@TooTallToby]

Aww yeah nice job Rob!

[@ciorad1389]

0.284 lbs, 10 min to do it. Dragos

[@TooTallToby]

Well done Dragos!

[@CerberaLM]

.2840 lbs in 7:59

[@TooTallToby]

well done cerbera!

[@bembsidi7557]

0.008 GRAM WITH MMGS 23MUNITS

[@TooTallToby]

Hey buddy! If the title block says IPS that means it’s in inches , and the answer is in pounds ( inch pound second)