How to wire and install printed inserts inside LED arcade push buttons
HTML-код
- Опубликовано: 12 сен 2024
- How to wire and install printed inserts inside LED arcade push buttons
Website:
www.retroactivearcade.ca
Subscribe!
/ retroactivearcadeca
Follow Us!
FB: retroactivearcade
IG: retroactivearcade
PIN: www.pinterest.com/retroactivearcade
Retro Active Arcade School of Arcade Building
diy.retroactiv...
I'm going to correct you Casey the black ring that you threw out is for metal control panels. If you look at the button the threads are a smaller diameter than the mounting hole. Same as the old leaf style buttons. That ring is so that you can tighten the buttons down properly. They also go under the control panel not on top of it.
I think that spacer you chucked is actually a washer for the nut...
Sorry I just posted that question under my daughter login. So Where can I get the push button Stickers? Also if I buy 12v lights for the buttons what power sourse do I use? Thanks and great videos.
You buy a simple power brick of the appropriate voltage off ebay or amazon
All that and doesn't show you the insert or led why?????
Do you guys do custom labels?
Sorry we do not :(
What sight do you sell the Push Button Stickers
TBrookeBeauty www.retroactivearcade.ca in the pushbutton section.
If I wanted to replace only the LED from the lamp holder, is that possible? If so what's the easiest way to do that?
You would just need to buy the LED and swap it out. If the lamp is removable and looks like this you are good to go! You just need to know if it is 5V or 12V and be sure to install it the same way is was when you took it out, it will not light up if you install it backwards so you will know right away. You can buy one here or search online for one wherever you like: retroactivearcade.ca/collections/led-lighting/products/12v-led
@@RetroactivearcadeCa Thank you! I have one of the chrome LED button lights connected to my arcade that won't unscrew. (the black plastic screw underneath) Whats the best way of loosening it without damaging ? Its not budging.
You shouldn't have to remove the button, just twist the lamp holder a quarter turn and it should just pop out. Then pull the led out and replace it. If you have to take it out you can use needle nose pliers and try your best but usually you would use a pushbutton wrench.
@@RetroactivearcadeCa I'm sorry I meant the spacer and nut. Both won't budge.
is a t10 led?
Depends on what type you are looking for but we have some lopsided on our website under pushbuttons at: www.retroactivearcade.ca
stop biting your fingernails dude