Dillon Square Deal B Case Feeder Measurements

One of my viewers (Roy) had some questions of measurements on the Case Feeder. So I did this short video to go some idea of what I did. As I said before there are no plans I did this as a one-off design and just worked it as I went. This is only what I did to make it work so the measurements are not set in stone.

[@ivymaturin3239]

Thanks so much for this 👍

[@backyardinventor9580]

anything is possible if you try hard enough, thanks for watching

[@roypiersel7021]

Thanks for doing this BYI. I see you measured the plate that attaches to the press, but other than the thickness, you did not measure the plate on the bench. can you confirm that it is 5"W x 3" D x 3/8" or 1/4" T?

[@backyardinventor9580]

Hey Roy just checked and the bench plate is 5 1/2 x 3 3/4 and 1/4 thick. Hope this helps, post some picture if you make one B/I

[@roypiersel7021]

@@backyardinventor9580 Thanks. I am securing materials. have a friend with the right tools. if I can get the camera and computer to communicate I will post when I get finished.

[@blainadams2544]

Hi would you build one and sell it