Power Supply Simulation on Proteus

12 volt DC Power Supply simulation using proteus simulation software. you can use this supply with electronics devices as well as for your customized project where dc power is required.
Component used:
Alternator (As AC source)
12-0 Transformer
Bridge rectifier
1000uf electrolytic capacitor
7812 ( fixed voltage regulator)
1k resistor
Led Yellow
Multimeter ( to check voltage)
Music By: NoCopyrightSounds

[@industrialelectricalbd6900]

so simple explain good job

[@mahadevikharade1683]

Thank you 🙏

[@Hariharan_Karthikeyan]

Can you upload about solar panel simulation in proteus?

[@kamranrasool5500]

Is this power regulad circuit... With ripple facture of 1?

[@emirhanayan8063]

How can I increase the current to 5 amps ?

[@talhashujaat2500]

Sir why u use resistor in this circuit diagram

[@zeyadhesham7472]

how do i change the voltage output to 9V?

[@SatyamsinghYT]

Hi, you can use 7809 voltage regulator instead of 7805.

[@zozam3638]

How can i make the output 5 volt like in phone charge plz reply me soon

[@SatyamsinghYT]

You can use this circuit to make that as well, or you can buy low cost smps circuit from market.

[@talhashujaat2500]

Secondly we u gave voltage V1 and next at regulator and with voltage source

[@SatyamsinghYT]

To limit the current for Led. otherwise, it will damage the led. and ve used probes to measure the voltage on input and output.

[@user-yf7dz6jh9q]

Sir please can you help me do simulation for our project rc coupled amplifier using proteus software kindly please reply sir 🙏 😢

[@SatyamsinghYT]

Pleased share block diagram of project on Instagram or mail. Insta : @ioturtle, mail : [e-mail]

[@user-yf7dz6jh9q]

@@SatyamsinghYT sir 🥺 thanks a lot 🙏 sir I will send in Gmail

[@user-yf7dz6jh9q]

@@SatyamsinghYT sir I sent you please check 🙏

[@adilsohail314]

proteus file kahan hai?