Making a drill bit cutting jig
HTML-код
- Опубликовано: 26 июл 2024
- I have a few large drill bits which have their tips destroyed.
Drinding those in a bench grinder woul be slow and produce a lot of grinding dust.
I will cut off the bad tip instead of grinding it off.
I need a jig to hold the drill bit while cutting the tip off with an angle grinder.
In this video I use:
- Schaublin SV-51 (1955) Milling machine
- Solberga (1975) Drill press
- Kemppi MasterTig MLS 2000 Welding machine
Chapters:
00:00:00 Opening animation
00:00:41 Introduction
00:03:22 Miling support plate for the vice
00:14:25 Drilling and tapping the support plate
00:30:28 Welding the support plate
00:48:31 Building the drill cutting jig
00:51:46 Cutting a drill bit using the jig
00:53:38 Testing the drill bit
00:59:28 Conclusion and end credits
The video is spoken in German but it has good quality hand written subtitles in English, German and Finnish. - Наука
loved the music. Brings back memories of my children's Irish dancing competitions.
good video finno
Nice work! I didn't realize you were doing these in German these days--with the English subtitles and my very small amount of German, that was fun!
Bester Mann.
Ich mag deine Videos sehr.
Rasittavia videoita.
Pultti ei sopinut kun ensimmäinen tappi oli aloitustappi, näki että tapin kierteen harja oli vajaa
Jousto tossa rällän kiinnityksessä voi vaikuttaa tarkkuuteen jos ei paina joka kerta just samalla voimalla ja samaan suuntaan