Dewalt DCS391 running slow? Try This!!

[@mrsmac5196]

Well done. The MFG is hoping we'll just give in and buy a whole new saw!

[@doctorlefthandthread]

Don't give up without a fight

[@itfc3]

brilliant video. how come you changed the whole bit and not just the brushes as i need to do mine.

[@doctorlefthandthread]

It comes with the full housing but you can solder in a set too
ruclips.net/user/shortsC2HAQxeL9Qw?si=2nYdUIbWZJzFvr1R

[@R0b87]

Thanks for this video, my saw started smoking from the motor. I suspect that the brushes are completely worn out and needs changing. Your video will be played at the same time I decide to open it and change those.

[@doctorlefthandthread]

Great job

[@clemmcguinness1087]

Good job
Ive one of these, good saws

[@doctorlefthandthread]

Good little saw cheap and powerful

[@thomasjervis490]

Ive the dcs391 type 10, making a grinding noise would that be a worn bearing on armature or gearbox? Thanks

[@doctorlefthandthread]

2 bearings in them in could be either or both

[@betoynorma]

I have 2 don't start what it could be

[@doctorlefthandthread]

Same thing brushes take off the black lid and check them

[@betoynorma]

@doctorlefthandthread i will thank you hope it works

[@elydominguez667]

Is it possible to just remove the parts if the brushes side and keep blade guard and all that staff on?

[@doctorlefthandthread]

There is a way I just filmed a video on that last night it should be out on Sunday

[@bigvi7623]

My friend do you know what size are 2 bearings?

[@doctorlefthandthread]

No but they are listed on the parts diagram www.mtmc.co.uk/Dewalt-DCS391-Type-10-Cordless-Circular-Saw-Spare-Parts__p-132057.aspx

[@bigvi7623]

@@doctorlefthandthread thx

[@slyfox186]

Moral of the story - buy a brushless motor saw

[@doctorlefthandthread]

Not a bad moral to have