Thank you very much Jeff for the videos of Vehicle Tracking they are very useful for me. I have a question. Is the vehicle you are driving in this exercise from the Civil3D library or have you created it? This vehicle is exactly what I need for my exercise and, in addition to this, I must analyze the vehicle in a tunnel. Is there a way to make a report of vehicle collisions with the walls and ceiling of the tunnel?
Hi I am trying to create ground conflict report using C3D 2018 and VT 2018, however it will only produce the sections showing where the ground conflict is. The line/hatch in the model showing the ground proximity wont show. i have cheek through all of the reports to ensure that it is not turned off with no results. Any ideas?
If the vertical clearance is more than 100 mm then no line/hatch colouring will appear on screen. The coloured vertical ranges that may appear on screen are: 50 to 100 mm clearance = green; 0 to 50 mm clearance = yellow; 0 to 50 mm ground penetration = orange; 50 to 100 mm ground penetration = magenta; over 100 mm ground penetration = red
Used this tutorial to check some raised concrete pedestrian crossings I'm designing. Helped a lot. Thanks Jeff!
Great tutorial series Jeff I watched all of them and learned quite a lot! Thanks again!
Great tutorial. how to I get the ground clearance key up??
Hi Jeff, thank you for the video very instructive. is it possible to modify the vehicle ground clearance without re-running the SPA?
Awesome tutorial. Is there a way where you can change the clearing warning symbol to different colour? instead of yellow?
Thank you very much Jeff for the videos of Vehicle Tracking they are very useful for me. I have a question. Is the vehicle you are driving in this exercise from the Civil3D library or have you created it? This vehicle is exactly what I need for my exercise and, in addition to this, I must analyze the vehicle in a tunnel. Is there a way to make a report of vehicle collisions with the walls and ceiling of the tunnel?
Superb Dear Sir may Allah Bless you
Hi everybody, how can i visualize the section created by the the analysis ?
Same question
@@andresjuarez3129 same
Excelent!
Great! I wish this was in spanish too. Haha thanks
Hi I am trying to create ground conflict report using C3D 2018 and VT 2018, however it will only produce the sections showing where the ground conflict is. The line/hatch in the model showing the ground proximity wont show. i have cheek through all of the reports to ensure that it is not turned off with no results. Any ideas?
If the vertical clearance is more than 100 mm then no line/hatch colouring will appear on screen. The coloured vertical ranges that may appear on screen are: 50 to 100 mm clearance = green; 0 to 50 mm clearance = yellow; 0 to 50 mm ground penetration = orange; 50 to 100 mm ground penetration = magenta; over 100 mm ground penetration = red