Been thinking about one of these lifts for a while now. Thanks for the video info. I was laughing at your remark about the old undies as a rag when my wife walked by and asked me what was so funny. She does my laundry, thinks its gross to use them "old drawers" as a rag! I've got a few in my rag container, they work great! 🤣
Quick question, what exactly are those safety clamps for that you had to call to get them sent to you? There really is no clear explanation in the instructions that say what they are for or what the purpose is.
They keep the hydraulic cylinder from dropping out of the lift head if pressure were to bleed off while a vehicle was raised and sitting on the locks, @@marlboro7546 . Hope that makes sense. I want to say they were an add-on (like a recall add-on), and Bendpak’s support people said they’re important to have on there.
![Blox Fruits Dragon Rework Update [Full Stream]](http://i.ytimg.com/vi/EqDAp8udhm0/mqdefault.jpg)
Been thinking about one of these lifts for a while now. Thanks for the video info. I was laughing at your remark about the old undies as a rag when my wife walked by and asked me what was so funny. She does my laundry, thinks its gross to use them "old drawers" as a rag! I've got a few in my rag container, they work great! 🤣
Hahahaha! My sense of humor misses more than it hits, but I’m glad I got a laugh from you, @@mikegrizwold2522. Thanks for the kind words!
Solid installation. Good job on the bolts bud.
Thanks Wes!
Awesome tool/lift😊
I’m really liking the capability it adds to the shop. 👍🏼
@@crazycaseyscustoms * I like that you didn't have to raise the roof!
That made it a whole lot easier, @@gallowaylights.
DUDE found your channel!!! This is SOOO rad man!!! Great to see ya and doing what you love!
Thanks Shelby! You too my friend.
Nicely done, looks awesome and fantastic model
Aww shucks! Thank you. 😊
Quick question, what exactly are those safety clamps for that you had to call to get them sent to you? There really is no clear explanation in the instructions that say what they are for or what the purpose is.
They keep the hydraulic cylinder from dropping out of the lift head if pressure were to bleed off while a vehicle was raised and sitting on the locks, @@marlboro7546 . Hope that makes sense. I want to say they were an add-on (like a recall add-on), and Bendpak’s support people said they’re important to have on there.
No thread sealer? Your going to have leaks
Mentioned the sealer @8:02 and again @9:41, and you can see it on the fitting @8:13.
Too bad the van can’t fit in an 8’ garage! 😂😂
Rotary is the only lift worth buying
I would challenge you to try and do a body swap on any of Rotory’s low-ceiling car lifts. And I don’t even think they’re American made, anymore…
Their website says “born and raised in the USA”, which probably means they moved overseas once they graduated. 😂