I've never used this tool, but I've seen a lot of reviews, and it looks great. Need it only for shrink tubes. I will buy it thanks to reviews like this.
I need a gun for installs. Mainly shrink tube. I woulsnt think twice about getting a cordes model, but sometimes there is no power depending on the work site. Ive heard the battery dies quite quickly (but how quick), and takes almost a minute to reach max heat. Any comments??
@bryanblaak Thank you very much for the feedback! I think I addressed the points mentioned in the video. You are also welcome to watch my other videos about cordless hot air blowers. ruclips.net/video/9Fgjx3_tpjA/видео.html This shows that the battery consumption of such a device is of course immensely high. For continuous use, I would assume a maximum runtime of around ten to 15 minutes. Due to the limited power of the battery-powered device, I would assume a maximum of 15 minutes. Due to the limited power of the battery-powered device, it naturally also takes a while for the device to heat up. Best regards
@viniciogomez9863 I have not explicitly tested this. However, I suspect that the temperature will not be sufficient to remove circuits / solder joints... Best regards
I've never used this tool, but I've seen a lot of reviews, and it looks great. Need it only for shrink tubes. I will buy it thanks to reviews like this.
I'm delighted to hear that the video helped you make your decision!
Thank you so much for your support! :)
Best regards
I need a gun for installs. Mainly shrink tube. I woulsnt think twice about getting a cordes model, but sometimes there is no power depending on the work site. Ive heard the battery dies quite quickly (but how quick), and takes almost a minute to reach max heat. Any comments??
@bryanblaak Thank you very much for the feedback! I think I addressed the points mentioned in the video. You are also welcome to watch my other videos about cordless hot air blowers.
ruclips.net/video/9Fgjx3_tpjA/видео.html
This shows that the battery consumption of such a device is of course immensely high. For continuous use, I would assume a maximum runtime of around ten to 15 minutes.
Due to the limited power of the battery-powered device, I would assume a maximum of 15 minutes. Due to the limited power of the battery-powered device, it naturally also takes a while for the device to heat up.
Best regards
Could it be used to remove integrated circuits?
@viniciogomez9863 I have not explicitly tested this. However, I suspect that the temperature will not be sufficient to remove circuits / solder joints...
Best regards