Grill - Siemens NX 12 Training - Part Design

[@nikhilgundras3471]

Great and learning so much from u..

[@wolfgang.walden.cad.training]

You´re welcome

[@girishgupta7719]

Good one!

[@wolfgang.walden.cad.training]

thanks :)

[@zakirhussain5465]

Thanks so much

[@wolfgang.walden.cad.training]

you´re welcome

[@velos26b]

Just a question, I don't understand that last thicken (0.5 mm), in direction inwards to the lateral surface, why? Finally, it would have been the same without using that thicken.

[@wolfgang.walden.cad.training]

No, this is a parasolid based software and there are some problems because of that. Without that thickening I was not able to do the 7mm rounds.

[@edneigomes]

Amazing Job.

[@wolfgang.walden.cad.training]

Thanks :)

[@sopankharche7523]

Automotive light reflector

[@wolfgang.walden.cad.training]

?

[@sopankharche7523]

Could you please make automotive light reflector in your next tutorial?

[@wolfgang.walden.cad.training]

@@sopankharche7523 Do you have a drawing of such a light reflector?

[@sopankharche7523]

No

[@wolfgang.walden.cad.training]

@@sopankharche7523 I see, I will consider it