I watched this video just for the punch settings and that’s exactly where u stopped at 😂 I can’t get the punch level to go 5. Once i reach option 10 it goes to 4 beeps then back to 1 for some reason.
Do they come already set from factory. I burned mine up in my punisher i reversed the battery leads .lol..my mistake .Or do 8 need to setup to my receiver
@@jonpg28 if the tires are labor A B C make sure they match up on the esc and motor. 2. On the remote you will see the TH ch, move it from R to N or N to R. If that does not work go into the esc programming and change the motor direction.
@UDRC85 they do match up when I replaced esc I put everything back how it was .Except wire to receiver I had it plugged into batt..instead of ch 2 so I was messing with esc .how do I reverse motor cause I'm thinking that's my issue
@@ExelArts you have the connectors in the wrong position. Go to the receiver box and swap channels 1 and 2. Channel 1 is for steering and channel 2 is for throttle. Someone plugged the steering servo into the throttle channel(2)
Nice turn up the BEC voltage while your at it
Will do brother.
What’s the benefits from turning up the BEC voltage guys ?
@@prycie1990 Faster servo..More power
I watched this video just for the punch settings and that’s exactly where u stopped at 😂 I can’t get the punch level to go 5. Once i reach option 10 it goes to 4 beeps then back to 1 for some reason.
The one beep after 4 is 5. Then six is one long beep then one more for six.
@@UDRC85 Thanks
Nice 👍🏾
Do they come already set from factory. I burned mine up in my punisher i reversed the battery leads .lol..my mistake .Or do 8 need to setup to my receiver
They come set up but, I recalibrate all the programmable esc’s because sometimes they are not set to max throttle from factory.
I got a question I replaced tje esc amd now when I engage the throttle foward it goes reverse amd vise versa
@@jonpg28 if the tires are labor A B C make sure they match up on the esc and motor. 2. On the remote you will see the TH ch, move it from R to N or N to R. If that does not work go into the esc programming and change the motor direction.
@UDRC85 they do match up when I replaced esc I put everything back how it was .Except wire to receiver I had it plugged into batt..instead of ch 2 so I was messing with esc .how do I reverse motor cause I'm thinking that's my issue
@@jonpg28 use the reverse switch on ST channel on remote or the esc. If that does not work I’d try to do a video later to show you what I am saying.
Does your CT2R controller have all dials set to 0 before you calibrate it?
Awesome 👌
Nice buggy
my remotes wheel is my throttle why?
@@ExelArts you have the connectors in the wrong position. Go to the receiver box and swap channels 1 and 2. Channel 1 is for steering and channel 2 is for throttle. Someone plugged the steering servo into the throttle channel(2)
@@UDRC85 did as you said and now i dont have throttle
this is on a team corally punisher
@@ExelArts flip the connector around the same port
@@UDRC85 still nothing but i lost steering from that
@@ExelArts do what said lol. Try to revere the channel on the remote.
i sure HOPE that it would NEVER DARE to say RTR on the box . would it .
It does but the Spark also have a roller version.