I’m replacing a burnt monster flywheel and a glazed monster clutch, all LS7 configuration. Do I need to remeasure if I’m using the LuK kit that has the same slave that’s in this video and my kit?
Do the ls7 and the ls6 slave with spacer measure the same size? I have the monster stage 2 clutch measures 2.500 and the ls6 with spacer but feels like my clutch is not fully engaged, was under the impression that the ls6 w/spacer and ls7 slaves where the same size
I know that make different spacer sizes so I'd have to say probably not. Always have to measure. If you had your flywheel resurfaced then the spacing will be different
Very helpful video . 👍 im working on and ls2 with the t-6060 and i was wondering if you know what slave cylinder to use due to took truck to dyno and seems like clutch its not disangaging all the way ? Thanks man
Mohd Ali so .37... don’t think you need any shim he said no more than 1/8=.125 so I think your good.. I just got .83 on my setup and I don’t think I need a shim either
I have a 2004 ctsv and need to replace the throw out bearing and wondering if the ls7 clutch slave fits right in.
So does it fit right in? or what adjust did you make after measuring it.
I’m replacing a burnt monster flywheel and a glazed monster clutch, all LS7 configuration. Do I need to remeasure if I’m using the LuK kit that has the same slave that’s in this video and my kit?
Mine is the same the one on the left could I use thus one agin
I got a 03 CTS installed a new clutch what's the best way to bleeding it
Do the ls7 and the ls6 slave with spacer measure the same size? I have the monster stage 2 clutch measures 2.500 and the ls6 with spacer but feels like my clutch is not fully engaged, was under the impression that the ls6 w/spacer and ls7 slaves where the same size
I know that make different spacer sizes so I'd have to say probably not. Always have to measure. If you had your flywheel resurfaced then the spacing will be different
Very helpful video . 👍 im working on and ls2 with the t-6060 and i was wondering if you know what slave cylinder to use due to took truck to dyno and seems like clutch its not disangaging all the way ? Thanks man
I used the corvette slave cylinder.
Please help my car in the garage now ,
A= 2.333
B= 1.963
What shim i need ??
Mohd Ali so .37... don’t think you need any shim he said no more than 1/8=.125 so I think your good.. I just got .83 on my setup and I don’t think I need a shim either
GTO GOOO sounds like yours has almost a 7/8 gap.
@@gtoctsv259 huh? wtf?
@Mohd Ali I am getting similar measurements. How did you fix this?