So I saw much oil on the pipe from the engine cover to the air intake. That should be the crankshaftcase ventilation. Is it correct, the PCV is failing and oil now goes in there? Also, is the PCV integrated in the rocker cover and to fix it, I can either change the whole rocker cover or do this PCV-delete with an oil catch can? I have a DS3 racing thp 207 from 2014.
Yes, I has been done twice now. You really loose a lot of horsepower and torque. Engine gives so much more response/power after a walnut blast session.
Dat is een onderdeel van Forge. Op de eerste THP modellen past de FMHP207, de latere de FMHP208. Indien de turbo lucht uitgang niet bovenop maar aan de zijkant van de turbo zit, heb je aan de helft van de FMHP208 niet veel...
So I saw much oil on the pipe from the engine cover to the air intake. That should be the crankshaftcase ventilation. Is it correct, the PCV is failing and oil now goes in there? Also, is the PCV integrated in the rocker cover and to fix it, I can either change the whole rocker cover or do this PCV-delete with an oil catch can? I have a DS3 racing thp 207 from 2014.
Could you please send me the dimensions of the bracket of catch can? I'm interested in both rear and front bracket sizes. Thank you!
What size are the hoses in mm?
Hi, what's the difference in this rear pcv and other one you installed earlier which is connected to air intake hose??
Would you recommend to get an oil catch can for a car that has excessive blowby. Also oil in intake manifold.
What size hose did you use to fit over the original cut pcv hose?
Share please the link, where i can buy this, thanks.
Nicely done. Looking good. 👍
Have you had your 3008 walnut blasted? Ours only has 44,000 miles on it and it just feels a bit flat.
Yes, I has been done twice now. You really loose a lot of horsepower and torque. Engine gives so much more response/power after a walnut blast session.
Hola desde Santo Domingo hablas español
Nice job. What is the size of the silicone hose you used?
16mm inner size
Hoe kom je aan die aluminium buis tussen de intercooler en het inlaatspruitstuk? (boven de distributieketting)
Dat is een onderdeel van Forge. Op de eerste THP modellen past de FMHP207, de latere de FMHP208. Indien de turbo lucht uitgang niet bovenop maar aan de zijkant van de turbo zit, heb je aan de helft van de FMHP208 niet veel...
Is this the same engine for 208 Gti facelift version ?
yes, the basis will be the same if you would like to add catch can(s).
Does this improve anything?
The catch can will prevent oil and other contaminants damaging the engine. What is catched will be shown in a later video.
Where can i buy the bracket?
The bracket is not for sale, it is custom made. Please check the video of the creation of the bracket.
is there a need for two cans I only have one which is at the front of the car
I would recommend to add the second as well, but the hose should be strong enough. I recently updated the hoses, will add the movie later online.
The main oil-steam is out of the rear recirculation.
@@SteveXP2 it depends weather you drive in traffic jams or highway
useless