This video helped me to align my bullets the correct way. Thanks! However this video (the others too) has a realy low resolution and you cant see details very well. Maybe its time to make some new hi-res videos :)
After all these years isn't it time to reduce the price to a more acceptable level? Around 300$ would seem plenty to have enough profit at the end, no?
I have this setup for 223 and it has serious problems with it. When the bullet is nose down it works, but when it is base down it kicks then out of the disk and they pile up. The bullets will go under the disk, on the floor and in general it stops the drive. I have watched the videos and they are of no help for this problem. Not worth the money spent.
I didn't see this video before unpacking my system. SHAME ON YOU !!! There was no tape retaining the inserts - they fell on the floor, and out in the trash they went. Unprofessional.
Exactly what I needed to know. Good demo.
This video helped me to align my bullets the correct way. Thanks! However this video (the others too) has a realy low resolution and you cant see details very well. Maybe its time to make some new hi-res videos :)
After all these years isn't it time to reduce the price to a more acceptable level? Around 300$ would seem plenty to have enough profit at the end, no?
Works very well!
I just wish there was a way to do wadcutters bullets as well...
Will this work with all presses and will it work with all caliber bullets? The question is will it work with lead bullets
Good information
clear as mud
Great product indeed! Too bad the price is really steep although I understand why.
Exactly where do the spacers go? on top or below?
To bad you don't answer your e-mail as I am having problem's. And can't get any help.
this work for cast bullets?
Will this work with Moly Coated Truncated cone 40 ???
I have this setup for 223 and it has serious problems with it. When the bullet is nose down it works, but when it is base down it kicks then out of the disk and they pile up. The bullets will go under the disk, on the floor and in general it stops the drive. I have watched the videos and they are of no help for this problem. Not worth the money spent.
I'm having the same problem. Any solution yet?
I didn't see this video before unpacking my system. SHAME ON YOU !!! There was no tape retaining the inserts - they fell on the floor, and out in the trash they went. Unprofessional.