What is Snap Lock Metal Roofing ?
HTML-код
- Опубликовано: 2 июн 2020
- In this videos we'll look at snap lock metal roofing. Snap lock is a type of standing seam metal roofing that uses a clip system to install so there is no exposed fasteners. The snap lock metal is a big upgrade from a corrugated or screw down metal roof and is a very popular type of metal roof. It is used on both commercial and residential roofing jobs and looks great.
Thanks for watching
Learn more at www.Exteriorproinc.com 
Хобби
So it is stuck down with Ice & Water. Permanently. No ability to repair an area that gets damaged ? Our current roof Architectural shingles is stuck down to I&W and I can't get any shingles off to repair a small area of the decking and then put the shingles back on or even replace a few if needed. Ours is a simple contemporary roof. No hips, no valleys, just one chimney on the front that insets 3 or 4 inches into the roof and a ridge vent at the top plus 2 or 3 vents. But, its a 2/12 pitch. Any recommendations. If you know of a way to unstick the shingles from the Ice & Water I would be forever grateful. Thanks for posting all these videos, I'm learning a lot.
Where can I buy this material near Toronto!?
Where can I buy 1" W x 1.75"H clips?
Expensive, time consuming prick to walk on but looks the part👍
Price per square foot?
right now i'd say around $3.00/sq.ft. for materials. Last year this time it was around $2.00/sq.ft.
Okay hoss, 1st) multiple manufacturers approve this product down to 1x12 pitch. 2nd) multiple manufacturers approve this product for installation over open purling without solid decking. That means no underlayment at all. Just 2x4s or 2x6s over rafters for commercial applications. Plywood's only required for residential. Yeah I've installed hundreds of projects with these panels. Not trying to be mean man but if you're going to get on RUclips and make a video make sure you really know what you're talking about!!
Most manufacturer's will not warranty this product (watertight warranty) over open purlins and on slope lower than 3:12. Wood deck or metal deck and iso with bearing plates under the clips are what are usually required for a warranty.
@@andrewkuhlman7464
I stand by my original statement. I've been doing nothing but metal roofing for over 30 years. You have no idea what you're talking about!
Is this available in pre-cut lengths for DIY’ers like other panels are?
@@NMranchhand It is ordered in specific lengths. So yes. But I do not believe snap lock standing seam is a DIY product. New or inexperienced installers always make mistakes. And given the cost associated with this product it is strongly advised to use a very experienced installer.
@@traceyjscott069 Thanks for that.