Thanks for this vidéo. I had the same problem since one month and i had the same diag of you, my left wheel back and front was not detect the spinning. So I changed too my left wheel sensors front and back with not result. So when I saw your vidéo whit this so dirty DCS connect I maked the same intervention and your right, the problème had here. I washed the connect and remove and all it's OK now. Thank's very much to you. But the realy question is where this water from ???
Great video, there's ICOM Next clones for £185 on Ali with all cables and MOST adaptor - there's some resistors that need swapping from factory, but after fixing that they're decent - have all the info. Handy to have a BMW backup
@@papitomallan9108 Sure but note this is for the single newer type single pcb version only and you'll need a scope as they're mostly 0602 packages. This will also fix the memory size which shows as 128mb but should be 256mb as it would appear at the factory they mixed up the component feeds, some are the wrong way around and others have the incorrect value. All technical info provided by Ferrum from Car Technology forum, well worth joining Swap R292R293 R155R156 R178R179 Solder new R15 52ом Replace R119 1к R280 R285 R195 38к Y4 active 33000 3.3v Here are some values if components are damaged during removal R155 1kom R156 72om R178 100k R179 1.4k R292 72om R293 1kom
Hey sir . I am having these same lights but even i had problem with speed meter , rpm meter and fuel level . Is that possible that connections between them ?
Hi buddy, where are you based , I have the same issue on a Bmw 730 F01 2009, only that mine has a stiff steering wheel and no speedometer. I need your help fixing it .. can't find a decent mechanic to find the problem near me.
hello i have a similar problem i have a 2010 bmw x6 e71 i replaced the abs sensor but my lights are still on diagnosis says it's the sensor again could be due to bad wheel bearing not recognizing it pls help
I had the same problem with a mini. But now I'm facing with a problem with coding. I got a question, to code the module I need to have the wheels on the ground?
Hello i have a problem with code 480aa0 dsc unit: internal hardware of software not released. All speedsensors read. Do you maybe know what could it be. Bmw f30
Not quite... Traction control is to control the traction on the wheels, while the ESP is to control the car, obviously including traction, in case of skidding... although ESP system usually do traction control as well... Thank you for watching and for your comment!
What are BMW thinking, putting electronic modules so close to water from the wheel wells? It looks like they do this so you have to spend ££ to repair them. I have a 320D and there are modules all over the place.
What a mission. The more I see the less I like modern BMWs, what a silly place to put an ABS module. It's going to get very wet even if you do not drive through floodwaters. If you are going to have an F10 you may as well make it an M5, not worth the hassle for something with a third of the horsepower.
😊 I actually agree... LoL That said, not the first time BMW placed the ABS module here... Did the same on the E60 M5... As was no room in the engine bay for it... Obviously different in this case... plenty space...😋 Thank you for watching and for your comment! 👍👍👍
You are so professional and honest. It's almost impossible to find people like you today
😊
Thanks!
👍👍👍
Having this problem for months and you are the first mechanic that figured this out… thanks
☺️
👍👍👍
Looking forward to the coding video. Thanks again a very detailed video and excellent video.
😊
Thanks!
👍👍👍
Detective work right there great find Luis Sterling job as always 👍🍻
😊
Thanks!
👍👍👍
Thanks for this vidéo. I had the same problem since one month and i had the same diag of you, my left wheel back and front was not detect the spinning. So I changed too my left wheel sensors front and back with not result.
So when I saw your vidéo whit this so dirty DCS connect I maked the same intervention and your right, the problème had here. I washed the connect and remove and all it's OK now. Thank's very much to you.
But the realy question is where this water from ???
To much exposure to splash water etc... and possibly poor seals...
👍👍👍
Incredible work, professionalism at the highest.
Well done
😊
Thanks!
👍👍
thanks for the video, good fix, with more people prepared to drive through deeper flood water I think we are going to see much more of this problem 👍
😊
Agree... lol
Thank you for watching!
Great fix Luis. Them pesky green crusties on the connectors again...
😊
Thanks!
👍👍👍
Great fix these BMWs are a nightmare if the battery is old and in poor condition 👍
Any car nowadays really...
Thank you for watching!
Another awesome find and repair Luis!!!
Thanks!
👍👍👍
Great video, there's ICOM Next clones for £185 on Ali with all cables and MOST adaptor - there's some resistors that need swapping from factory, but after fixing that they're decent - have all the info.
Handy to have a BMW backup
sounds interesting, could you show what resistors needs to be replaced?
@@papitomallan9108
Sure but note this is for the single newer type single pcb version only and you'll need a scope as they're mostly 0602 packages.
This will also fix the memory size which shows as 128mb but should be 256mb as it would appear at the factory they mixed up the component feeds, some are the wrong way around and others have the incorrect value.
All technical info provided by Ferrum from Car Technology forum, well worth joining
Swap
R292R293
R155R156
R178R179
Solder new
R15 52ом
Replace
R119 1к
R280 R285 R195 38к
Y4 active 33000 3.3v
Here are some values if components are damaged during removal
R155 1kom
R156 72om
R178 100k
R179 1.4k
R292 72om
R293 1kom
Heated door handles can cause same problem as on same network, had a red hot rear door handle that shorted internally.
Hey sir . I am having these same lights but even i had problem with speed meter , rpm meter and fuel level . Is that possible that connections between them ?
Possibly...
Have you scanned the car?
👍👍👍
Another great video, thanks. Is it possible to code the module with other tools, except maxisys?
Yes... there is other tools that can do it...
Thank you for watching!
Esys soft is for F serie BMW!
Hello Luís! Another great video! Can you tell me the name of the music you used as soundtrack when you were bleeding the brakes?
It's called Nimbus...
I got it from the RUclips collection ages ago...
Thank you for watching!
Hi buddy, where are you based , I have the same issue on a Bmw 730 F01 2009, only that mine has a stiff steering wheel and no speedometer.
I need your help fixing it .. can't find a decent mechanic to find the problem near me.
Well done again BM troubleU, what a shame, them silicone seals around the pins aren't worth a dime,are they?
Not at lot by the looks of it...😋
Thank you for watching!
Nice! Without a subscription, maxisys doesn't allow any coding?
It does coding, but not flashing...
Thank you for watching!
👍👍👍
hello i have a similar problem i have a 2010 bmw x6 e71 i replaced the abs sensor but my lights are still on diagnosis says it's the sensor again could be due to bad wheel bearing not recognizing it pls help
Impossible to say without checking and testing...
👍👍👍
seen this before, where the signal is missing, the ABS software will copy other side,
I had the same problem with a mini. But now I'm facing with a problem with coding. I got a question, to code the module I need to have the wheels on the ground?
No...
Thank you for watching!
hi i have a similar problem. do you think you are able to fix this?
I think it has like the golf had or the signal isn't getting to the ABS module
😊
👍👍👍
Where is your garage or place to work as i definitely need yout help with probably the same problem !?
It is just a part-time for me...
👍👍👍
Great video! But you definitely need a garage to work with the car lift!!!
😊
Thanks...
👍👍👍
What can cause the light chassis stabilization drive moderate to come up and how to fix it
Scan the car first...
It can be many different things causing that...
👍👍👍
Hello i have a problem with code 480aa0 dsc unit: internal hardware of software not released. All speedsensors read. Do you maybe know what could it be. Bmw f30
What is the background?
Just happened, or have you replaced anything on the car?
👍👍👍
@@LMAutoRepairs i got it like this,nothing replaced by me. I just have abs,dsc and tyre pressure light. 2014 316d auto
@MrSpeedkg
Check live data... if the description of that code is correct, could be a software issue, perhaps a reprogramming might help...
Hello mate, is that web forum u set up still going? If so could u let me have the link? Thanks
Yes... it is still going...
prodiag.boards.net/
Thank you for watching!
Thats a great place for abs module.
😊
Where are you located?
Hi I looking forward for recoding 😁good video
Coming next...
👍👍👍
Sir make a video on online coding or programming
👍👍👍
I have published some already...
Thank you for watching!
this is a new customer, he has too much fuel for my taste
😊🤣
Is traction control like ESP
Not quite...
Traction control is to control the traction on the wheels, while the ESP is to control the car, obviously including traction, in case of skidding... although ESP system usually do traction control as well...
Thank you for watching and for your comment!
Hi you could code the module with your IM608 if you still have it. thumb up to you you do always great work 👍👍👍👍
As you will see when the video for it is published, in this case yes...
Thank you for watching!
👍👍👍
the army of the green crustys...strikes again.
great diag.
😊
Indeed...
Thank you for watching!
Good Job! Congratulations
Thanks!
👍👍👍
The diesel light isn't on like normal
😊
@@LMAutoRepairs It must feel so strange
What are BMW thinking, putting electronic modules so close to water from the wheel wells? It looks like they do this so you have to spend ££ to repair them. I have a 320D and there are modules all over the place.
🤷♂️
It is definitely not the first time BMW did this...
Same on the E60 M5...
Thank you for watching!
👍👍👍
thank you man
you are great
😊
Thanks!
👍👍👍
is it 1000 pounds year bro? for subscription
Yes...
Thank you for watching!
@@LMAutoRepairs excellent job well done once again :)i have learned so much from your vids ty :)
😳 The little things they don’t tell you!! No point buying that as a weekend casual mechanic. Won’t be buying one of those then.
👍👍👍
You have cheaper tools for the casual weekend user...
👍👍👍
Which model autel ?
MS908P
👍👍👍
@@LMAutoRepairs maybe ask what did you recommended diagnostic tool like litte bit same like your autel but price quality and can be coded.
👍🏻👍🏻👍🏻👍🏻🌷
☺️
👍👍👍
What a mission. The more I see the less I like modern BMWs, what a silly place to put an ABS module. It's going to get very wet even if you do not drive through floodwaters. If you are going to have an F10 you may as well make it an M5, not worth the hassle for something with a third of the horsepower.
😊
I actually agree...
LoL
That said, not the first time BMW placed the ABS module here...
Did the same on the E60 M5...
As was no room in the engine bay for it...
Obviously different in this case... plenty space...😋
Thank you for watching and for your comment!
👍👍👍
top
Thanks!
👍👍👍