I own the same crawler. Im having issues with climbing a hill or pushing the right side looses pressure or will not pull and times it all works ok if i pull the left level it will stop pulling then have to clutch it and it will take back off. if Im backing up on a hill it will not move until i pull the right lever. Any help would be greatly appreciated I just recently had the right side fixed as in broken hose that supplies the fluid to rear and a bearing on the final drive $4,000 fix. now this thank you
On mine I find if I don’t idle the machine all the way down it’s not wanting to shift gears. If I idle down it slips into gear fine but if it’s at high rpm, doesn’t want to go in easy. It’s not a problem I was wondering if this is normal.
I own the same crawler. Im having issues with climbing a hill or pushing the right side looses pressure or will not pull and times it all works ok if i pull the left level it will stop pulling then have to clutch it and it will take back off. if Im backing up on a hill it will not move until i pull the right lever. Any help would be greatly appreciated I just recently had the right side fixed as in broken hose that supplies the fluid to rear and a bearing on the final drive $4,000 fix. now this thank you
Good job!
I have a very similar issue with my 450C... Was wondering what the final outcome was on this machine?
Thanks
Customer wanted to wait and pull it apart himself. I didn’t end up solving it for him.
On mine I find if I don’t idle the machine all the way down it’s not wanting to shift gears. If I idle down it slips into gear fine but if it’s at high rpm, doesn’t want to go in easy. It’s not a problem I was wondering if this is normal.
Did you figure out what it was? I have the same issue.
Have a 350. Runs like a top, but will not move... any tips? Same vintage as this machine
Pull your floor boards and check the big nuts on the transmission housing to axle housing. If they are loose its likely a broken reverser.
Well? Did it operate once you freed up the throw out bearing? How did you fix it?
I just asked the same thing. Did he respond to you at all?
Customer wanted to wait and pull it apart himself.
Thank you
Thanks for the update!
It’s the washers on the clutch pedal, mine wouldn’t push at all, took washers out and pushed like new