How to: Replace ON OFF Switch. Honda Small Engine GX Series - GX390
HTML-код
- Опубликовано: 23 июл 2024
- Step by step we show you how to easily replace the ON/OFF switch in your Honda GX Series small engine. **The wire colors vary with manufacturer, but we show you how to trouble shoot that and how to connect a ground wire vs. a ground tab.
There are many switch brands available. We used Aufee (part #) X002WKEK7L
www.amazon.com/gp/product/B07...
0:00 Introduction and Part #
0:13 Preparation and Disassembly
2:06 Remove old switch, put in new switch
3:08 Assembly
4:20 Trouble shoot Wiring (color mismatch)
5:03 Wiring and Assembly con't
#hondasmallengine #gx390 #hondagx340 #hondagx270 #hondagx240 #hondagx200 #hondagx160 #hondagx120 #hondagx110 #diy #howto #hondagxseries #smtv Хобби
Mine is fixed. Thank you!
You're welcome, glad it helped! Thanks for watching.
There is a wire that pass below the gas tank want to know where the upper end attach it comes out and i dont where
How do you start,with your pull rope at the 7 oclock position?
It's because it is mounted on the sled of a bandsaw mill. It raises up and down determinate of the log diameter and since I don't like to waste gas while turning/squaring logs (the channel is called Save Money, after all 😊) I frequently need to pull start when the mill head is raised up and hence buried behind the basket and frame of the sled. This is a good compromise to allow me access no matter the height of the mill head.
Great question, thanks for watching!
if your switch is stuck in the on or off position and doesn't turn anymore, you don't need to replace the switch.
Just disassemble the knob by removing the retainer clip behind the knob, and remove the spring loaded ball bearing inside along with that spring. Then reassemble.
The knob will continue to work without the ball bearing.
If you're too lazy to remove the ball bearing, you can buy a new switch for about $1 on aliexpress or temu.
Great tip, thanks for sharing!
Know