If you flip the hole saw upside down when you’re squaring it up in the middle I found it easier to see where the middle was since the hole on the saw that attaches to the drill is right up against the t top. It’s more accurate which helps prevent you from scratching up the powder-coated inside of backing plate
I just received my deluxe bases, and noticed that Ron didn’t use the foam gasket in this installation. Should I use it or just use 5200 as seen in the video?
If you flip the hole saw upside down when you’re squaring it up in the middle I found it easier to see where the middle was since the hole on the saw that attaches to the drill is right up against the t top. It’s more accurate which helps prevent you from scratching up the powder-coated inside of backing plate
I just received my deluxe bases, and noticed that Ron didn’t use the foam gasket in this installation. Should I use it or just use 5200 as seen in the video?