Ok I think I found the chart for the inline weights for example 2oz at 1.5mph 50feet back gets me 17feet deep… is it at that 50 feet back mark I’m clipping on a inline board? Then letting board out to whatever
@@jarretmoore3858 the weight will be at the same depth. The lure will then dive below the weight based on using 50' of line. A Reef Runner 800 would run about 14" deeper than the weight, a Flicker shad only about 8' deeper than the weight
Thanks for sharing. Will try this method for sure. Will become very handy in order to place crankbaits at fish level in open water.
Great explanation… I have a question if using inline weight say 6 feet before harness is there a dive curve chart for that lure depth
Ok I think I found the chart for the inline weights for example 2oz at 1.5mph 50feet back gets me 17feet deep… is it at that 50 feet back mark I’m clipping on a inline board? Then letting board out to whatever
what about not using boards?
Will the lures also determine depths
So like flickers vs reef runner both out 50 ft
@@jarretmoore3858 the weight will be at the same depth. The lure will then dive below the weight based on using 50' of line. A Reef Runner 800 would run about 14" deeper than the weight, a Flicker shad only about 8' deeper than the weight