Awesome, just make sure to not make it carry too much weight (too high current flow to the motors from the ESCs) by not using a very large extra battery, and don't connect them together unless the voltage is about the same for both batteries. To be sure, fully charge both batteries separately, then connect them. Also make sure that the extra battery has the same number of cells as the original battery. I don't know the cell count for the Spark batteries, but it should be stated on the sticker (1S=3.7V, 2S=7.4V, 3S=11,1V, 4S=14,V Nominal)
It would be nice if you could have added commentary, what's the flight time with the mod? Where did you buy the battery? All of this would be extremely helpful
I can’t believe nobody has said this yet, but DO NOT connect a fully charged pack directly in parallel with a discharged pack like this! You are extremely likely to damage the pack, but could start a fire too! It will push hundreds of amps through that connector. Good instruction for setting up the battery for charging with a hobby charger though.
Both pack were fully charged. The flight pack simply didn’t charge up to full 4.2 per cell... he used the big pack to boost up the flight pack right before takeoff. It’s harmless.
From what I can see you did not remove the dji battery but added a cable plus adapter to add another battery... Surely this adds to the flight weight meaning you're not actually getting extra flight time because the spark has more weight to lift?
Thank you very much indeed for this video!!! Now I see that it's real to increase the Spark's flight time. But I have one question: what about the battery controller? How the controller reacts to the external power bank? Should I make any manipulations with its firmware or something?
The only problem I see with this is that the internal battery should match the same Mah than the external one. In theory, the miss-match will make the less mah battery drain first and will have a drop-down from 3.2 killing the cells unless somehow you can balance one to each other.
The main will always drain faster, less resistance. Finding the right external to match the draw rate of the main in flight is the tricky part, that said I’m always destroying batteries.
Great video ! The best one about this mod I could find in youtube !! Can you tell me which wire is positive, and which is negative, since u used two black wires on yours ?
Thank you for this awesome video. I have one question after doing this operation then you charge original batteries additional battery also will be automatically charged or you have yo charge it separately with another battery ? Thanks
why is that one gets a N/A instead of % icon in battery information? you also have N/A sometimes..... i did the procedure and after reasembling all i can read N/A and no voolt on individual cells..... what did I fry? :(
Check the pin connector of your battery, look for bent pins and the charger. Clean it with alcohol, you can also clean it with mineral oil, but use a tiny amount.
dead cell means higher resistance which is not good :) , it migt be just drained though .. that's another story , and yes dead (drained) batteries can be revived ..
Looks like it is a pair of tweezers, anything along that line to defeat the snap locks like taking a tablet apart..a spudger, small screw driver ...etc
ok, very nice to share this, but if you say some more important things, like how much more flighttime/where can we purchase this battery/ show it by fly the Spark, would be real helpful, I think ;] .. May be you consider to fly Spark etc. and show it too..thnk in advance ..
Hi! Thanks for the video it's really interesting, I might try for fun, one question : the weight of the battery (about 100g?) doesn't disturb the drone flying?
Hi Yeah nice for fun but unfortunately will not fly with and extra 200g is twice time the batt. the battery on that video is about 250g, Spark can't take off with an additional twice time own batt, is like putting 1 batt with aprox 290g.
Hey, does the dji spark have a cell lock? i kinda wanna do the battery mod but with removing the original cell and just using the external battery soldered to internal bms. can you tell me if its gonna work or not? thanks
We never see the drone flying, with the battery added, i mean the battry added is almost the size of the drone, how the drone is gonna support all that weight ?????
Das habe ich auch alles so nach gemacht und bei mir ging meine Spark an und es waren die LEDs waren rot und im Handy bei der App 4go karm Akku Fehler??
At most you’ll only fry the pack. Which is around 50 bucks.This mod, for the cost of a extra lipo pack let’s you fix the atrocious flight time of the spark which I personally feel is totally worth it.
Awesome, just make sure to not make it carry too much weight (too high current flow to the motors from the ESCs) by not using a very large extra battery, and don't connect them together unless the voltage is about the same for both batteries. To be sure, fully charge both batteries separately, then connect them. Also make sure that the extra battery has the same number of cells as the original battery. I don't know the cell count for the Spark batteries, but it should be stated on the sticker (1S=3.7V, 2S=7.4V, 3S=11,1V, 4S=14,V Nominal)
It would be nice if you could have added commentary, what's the flight time with the mod? Where did you buy the battery? All of this would be extremely helpful
I can’t believe nobody has said this yet, but DO NOT connect a fully charged pack directly in parallel with a discharged pack like this! You are extremely likely to damage the pack, but could start a fire too! It will push hundreds of amps through that connector.
Good instruction for setting up the battery for charging with a hobby charger though.
Exactly!
Both pack were fully charged. The flight pack simply didn’t charge up to full 4.2 per cell... he used the big pack to boost up the flight pack right before takeoff. It’s harmless.
From what I can see you did not remove the dji battery but added a cable plus adapter to add another battery... Surely this adds to the flight weight meaning you're not actually getting extra flight time because the spark has more weight to lift?
Thank you very much indeed for this video!!! Now I see that it's real to increase the Spark's flight time. But I have one question: what about the battery controller? How the controller reacts to the external power bank? Should I make any manipulations with its firmware or something?
Bro hello Ihave dji spark What battery do I use to have approximately 30 minutes of flight? I appreciate your answer nice day
The only problem I see with this is that the internal battery should match the same Mah than the external one. In theory, the miss-match will make the less mah battery drain first and will have a drop-down from 3.2 killing the cells unless somehow you can balance one to each other.
The main will always drain faster, less resistance. Finding the right external to match the draw rate of the main in flight is the tricky part, that said I’m always destroying batteries.
what if we use two spark batteries ? is it possible ?
5
Great video ! The best one about this mod I could find in youtube !! Can you tell me which wire is positive, and which is negative, since u used two black wires on yours ?
Same doubt. Have you discovered? Abraço!
He marked it with a marker in the video at 5:55🤨
Nice! So simple it is if you know how. Thanks for the video! I think it works on mavic air battery's too. 🤔
Hi my friend can you do this also for the DJI mini thanks
ruclips.net/video/pL0dGoH2AC4/видео.html
Thank you for this awesome video. I have one question after doing this operation then you charge original batteries additional battery also will be automatically charged or you have yo charge it separately with another battery ? Thanks
Thanks, you need to charge the main stock battery and the external separately.
@@FlyFarandWide thank you.
why is that one gets a N/A instead of % icon in battery information? you also have N/A sometimes..... i did the procedure and after reasembling all i can read N/A and no voolt on individual cells..... what did I fry? :(
Check the pin connector of your battery, look for bent pins and the charger. Clean it with alcohol, you can also clean it with mineral oil, but use a tiny amount.
bro this mod can revived dead cell inside battery?
dead cell means higher resistance which is not good :) , it migt be just drained though .. that's another story , and yes dead (drained) batteries can be revived ..
Yeah thankyou sir
Nice Video..
Good information..
how size of awg you use ??
Thanks, 18awg
What kind of batteries you used and how much capacity has pls link of the battery
I use all sorts, probably the best all rounder is the MaxAmps 1850mAh 100c.
www.maxamps.com/lipo-1850-3s-11-1v-battery-pack
Fly Far and Wide thanks bro
how long is the battery life for that kind battery sir?
Sell the modded spark batteries and become a overnight millions
Can you tell me the name of that special tool you used to open up the battery :)
Daughter: ‘where has all my cutlery gone?’
Looks like it is a pair of tweezers, anything along that line to defeat the snap locks like taking a tablet apart..a spudger, small screw driver ...etc
I think it is a butter knife. Lolx
since I got a damaged battery I might do this?
Did you solder the wires to Clock negative/positive!
Will you be able to use a trickle charger with this set up?
ok, very nice to share this, but if you say some more important things, like how much more flighttime/where can we purchase this battery/ show it by fly the Spark, would be real helpful, I think ;] .. May be you consider to fly Spark etc. and show it too..thnk in advance ..
Late comment I’m sorry, but I was wondering if there’s a way to do this on a mini?
ruclips.net/video/pL0dGoH2AC4/видео.html
So how long does the flight time last with this Mod?
Donald Arbolario it depends on what external you pair it with.
@@FlyFarandWide can i connect the cell of a powerbank to the battery? Like a 5000mah cell?
It needs to be 3s
@@FlyFarandWide thank you..
hello how minutes fly time after add this battery??
+3 min
3mins is nothing .... If 10mins is added then great
Do you change to non-dji battery from DJI aast 2 ??
I do yes
Hi! Thanks for the video it's really interesting, I might try for fun, one question : the weight of the battery (about 100g?) doesn't disturb the drone flying?
Of course it does thi video is bullshit
Hi Yeah nice for fun but unfortunately will not fly with and extra 200g is twice time the batt. the battery on that video is about 250g, Spark can't take off with an additional twice time own batt, is like putting 1 batt with aprox 290g.
I have the same doubt...
Good question.does it hurt the drone carrieing another battery not hurt it but is it noticable
@@partilhamusicosmica Again with the "same doubt" response?!
Hey, does the dji spark have a cell lock? i kinda wanna do the battery mod but with removing the original cell and just using the external battery soldered to internal bms. can you tell me if its gonna work or not? thanks
Hi... So... You use lipo battery 3cells and connect this at spark battery really? Sorry for mi English
13v lipo vs 13v SPARK
Usless.
Spark is short range selfie drone.
With 4 battery's you are king.....
King 👑 of the 🏰
why did I try to fly for even less time what do you think the cause is sir?
Wow nice
We never see the drone flying, with the battery added, i mean the battry added is almost the size of the drone, how the drone is gonna support all that weight ?????
With that extended battery that spark will be an DJI fly battery😅😅😅😅
My mavic air battery discharge completely and now don't charge. It have 11. 4v bun led don't light up. What can i do?
Charge it in the drone, if that doesn’t work remove the cells and make an external battery with it 😁
does it work with a lipo 3s 1500mha 35c battery?
Can you please show how to make the antenna you are using thx
Okay I will sort something soon.
Hi, ur videos are awesome, im can put lipo 3s 1300mah 25c ? 25c is great discharge?
Thanks, yeah 25c should work okay, the higher the better with the spark really.
Right, ty man
Hi man, is 2022 April, un My contrybits hard to find batteries for My spark, You know how to fix ald batteries?
I've many WORKING battery to sell
does it work also when the spatk batterie died ?
Hi, can I use 2200mah 3s lipo with 30c?
In theory yes
@@FlyFarandWide mine has a total load of 220 ory batteries how come it can't fly what is the cause?
Can you please tell us how to find the + and _
12V external battery ?
Is the battery still under warranty lol
Das habe ich auch alles so nach gemacht und bei mir ging meine Spark an und es waren die LEDs waren rot und im Handy bei der App 4go karm Akku Fehler??
Yes spark is ok
Am I been thick,what was it showing us bigger capacity or please tell me
Chris Allott the ability to connect a second battery.
Doesnt that have an impact on weight,I wouldnt no where to start and what type of battery it needs
The extra weight doesnt overload the motors?
yes it will , make it louder, more slugish, make it run hotter, and possibly less fly time, lol.
Very good video !
And very good choice of music to suit it 👍
Hallo an alle, 1500 mah und wie viel Volt??
❤🎉😮😊 ไฟไฟไฟแอดพ์
Just buy more spark batteries. Or upgrade to a mavic that has longer flight time. Why risk damaging the spark with a mod like this?
not for you then buddy?
At most you’ll only fry the pack. Which is around 50 bucks.This mod, for the cost of a extra lipo pack let’s you fix the atrocious flight time of the spark which I personally feel is totally worth it.
How long extra mins flight did the mod hack provide ...is it possible to get 25mins
Spark cannot fly with this battery weight. Spark bu batarya ağırlığyla uçamaz.
You can see lots of videos of the Spark doing it in this channel bro. Hugs!
2S or 3S LiPo? 11.1V 3S 35C?
Is got to be 3s in parallel with the stock main battery, 35c is plenty.
but where's the video showing the test ??
On my channel 🙂
@@FlyFarandWide link
What's the name of the song?
Wow.
10 mins is more than enough flight time, all you have to do is change battery an you have another 10 mins, how long do you need to get the shot? lol
Not if the ‘shot’ is 5 miles away 🙂
@@FlyFarandWide somehow mod a Mavic mini 1 battery to a spark one
Complete BS glad I skimmed thru this mess. This is just a different way to charge
Okay sweetheart
What a waste of time