Air assistance works more for cutting than engraving. I have a Zbaitu laser and last night I bought an Atomstack. Right now I'm going to buy that air assistant pump, I like the color hahaha.
Hello, i'm looking for the air assist power cable. Do you know where i can buy it? Or can you tell me which is the barel jack used from pump side? Thank you in advance.
We aren't sure where you can buy it, you could probably try to reach out to support at AtomStack to ask about a replacement. The pump side barrel jack is 3.5mm and the laser side is 5.5mm barrel jack. Hope this helps!
@@ProjectAnonymous_Duo thank you . Appreciate your response . I also think it helps in correct alignment of laser , especially when using user origin method . Thanks once again.
my diy airassist on my janky co2 makes a ton of difference for cutting (not much for engraving). This one i'm not sold on after your video.
Air assistance works more for cutting than engraving. I have a Zbaitu laser and last night I bought an Atomstack. Right now I'm going to buy that air assistant pump, I like the color hahaha.
Thanks for sharing and watching!
Hello, i'm looking for the air assist power cable. Do you know where i can buy it? Or can you tell me which is the barel jack used from pump side? Thank you in advance.
We aren't sure where you can buy it, you could probably try to reach out to support at AtomStack to ask about a replacement. The pump side barrel jack is 3.5mm and the laser side is 5.5mm barrel jack. Hope this helps!
Thank you
Hi where did you get the grid spoil board under the honey comb?
We are just using a self healing mat to protect our table under the honeycomb bed. Here is a link to see what it is: amzn.to/3TEcKOB
@@ProjectAnonymous_Duo thank you . Appreciate your response . I also think it helps in correct alignment of laser , especially when using user origin method .
Thanks once again.