SSX23 / MK23 Nozzle Spring Upgrade Installation | TRIDOS.DESIGN

In this video we go over on how to install the stronger SSX23 / MK23 nozzle springs inside the blowback / nozzle unit. These are useful for improving consistency, reducing feeding issues and eliminating stricky trigger problems.
These will increase the trigger pull weight a little bit.
Buy the SSX23 / MK23 Nozzle Spring Upgrade: tridos.design/collections/ssx...

[@shaun536]

I bought my gun used. But when going over your video to doing this I noticed that my long spring on the top has a c channeled type bar that is compressing that spring. Do you know what the purpose of the bar is? Also when doing this spring change should I put that bar on to compress this new spring?

[@TRIDOS.DESIGN]

That's done on some of the clone MK23's to achieve similar effect to what our stronger springs do. It was a cheaper fix for them to add that piece than to make a new spring I supose. You shouldn't leave it in there if you're changing to our springs.

[@MrSoulcaliburs]

Bonjour pouvez vous confirmer que le kit uograde spring ne casse pas le nozzle ? Car j'ai déjà essayé autre fournisseur et même en changent le nozzle complet il se cassait au niveau des patte fixations

[@TRIDOS.DESIGN]

We haven't seen any of such issues on our springs. If that happens, please reach out to us and we'll take care of it.

[@user-hf9jd4ev7u]

I just installed this upgrade and the springs feels much stronger but somehow i went from ~70m/s with 0.32 to 50m/s.. do you know what may cause this issue?
The nozzle is properly fitted back in the slide and moves freely

[@TRIDOS.DESIGN]

Was this the only upgrade / change you made?