Learn how to import non-Chromeleon data and perform general processing steps such as peak integration, component table generation, and calibration plot creation.
Good afternoon I would like to know how the signal-to-noise ratio is calculated in crhomeleon for the purposes of calculating the detection and quantification limits. Thank you so much
When creating a new processing method on its own, how can I add additional UV-channels? All integration settings apply to all channels and I can't add more channels
I am following the procedure- 1. First creating variable in the injection list for sample weight (batch specific) and others (fill weight or average weight). Putting their values before run. 2. Secondly i am creating processing method where two variable created for each component and putting values ( standard weight and standard potency, factor = conversion factor). 3. In reporting template creating formula by calling created variables. Then reporting with unit as required. 4. For next analysis i copied the variable and formula from same sequence and done. Is it ok?
Very helpful video. Thanks a lot. Sir can u please share how can we plot calibration curve using multiple injection results. As for example I hv chromatogram for 10pppm, 20pppm, 30ppm, 40ppm, 50ppm. Now I want to draw the calibration curve for this
This is really really informative. Thank you so much for sharing.
Thank you very much Joel to post this video. It is definitely very helpful for first time user!
This was so helpful, thank you so much!!
Thank you very much for this excellent opportunity to understand how to proceed to process data !
Wonderful elaboration of each and every single parameter
Thank you Joel, very helpful!
Nice tutorial. It would be nice if you would upload some more information about chromeleon. Especially some more info about calibration,
2:50 Import data
7:09 Processing data
20:18 Processing method
27:03 Quantitative method
28:08 Start integration
29:09 Run Cobra Wizard
thank you for sharing the time stamp 🙏
Muy bien video,saludos desde Mexico
Great job. What about the reporting video. Is it out yet?
Superb!
can you please make video on calibration of ic soft ware is chromeleon
Good afternoon
I would like to know how the signal-to-noise ratio is calculated in crhomeleon for the purposes of calculating the detection and quantification limits.
Thank you so much
thank you so much, it was wonderful.
I just did not understand the level part in 13 min. why some level will be 1 the other will be 2?
When creating a new processing method on its own, how can I add additional UV-channels? All integration settings apply to all channels and I can't add more channels
and is there any video about assay test and RSD calculation?
Thanks 💜💜
I am following the procedure- 1. First creating variable in the injection list for sample weight (batch specific) and others (fill weight or average weight). Putting their values before run. 2. Secondly i am creating processing method where two variable created for each component and putting values ( standard weight and standard potency, factor = conversion factor). 3. In reporting template creating formula by calling created variables. Then reporting with unit as required. 4. For next analysis i copied the variable and formula from same sequence and done. Is it ok?
Very helpful video. Thanks a lot.
Sir can u please share how can we plot calibration curve using multiple injection results. As for example I hv chromatogram for 10pppm, 20pppm, 30ppm, 40ppm, 50ppm. Now I want to draw the calibration curve for this
Your going very fast