Clean your k40 mirrors in 5 minutes

[@sandlinjames]

Thanks so much; still learning the basics around maintenance & this helps greatly.

[@philscraftcorner]

I'm glad this helped you

[@たけ-i2g3l]

thanks a lot! I was about to buy new laser tube but thanks to your vid Ididn't have to!

[@philscraftcorner]

That's great news!

[@Alan-mg1rp]

exactly the same way I do mine but struggle getting the lens the right way round ...

[@philscraftcorner]

It takes a bit of getting used to but once you do it's pretty clear which way they go

[@philscraftcorner]

Hi raj. Im not too sure if it's a good idea to post your phone number on social media like that. What kind of issues are you having?

[@rajeshmistry8390]

@@philscraftcorner
Phil
I've just bought this, it want go back to 0 ( X and Y ) point after each job

[@philscraftcorner]

Hi. This will depend on your software. I use k40 whisperer and in the settings I can set it to return home, unlock the rail or beep. Have a look around in your program settings

[@rajeshmistry8390]

@@philscraftcorner
Thank you Phil will try it tomorrow