Reverse engineering with Creo 4 - Introduction

[@user-ij9uk2ly7s]

thank you so much for this video

[@OKDedic]

Thanks for the video, it is very useful.
The groove is 8 mm wide. From the table, select above 22 to 30.
You chose above 30 to 38.
The 3 holes on the side are for balancing run out the pulley and are not drawn.

[@thaisonbui3019]

Looking forward to learning ah from videos like this! thank you

[@kamleshkailasjoshi2620]

Thank you so much sir

[@tothrichard6879]

Thanks for video. It is very useful. I would ask, is it able to get the sketch with “project”? I need help with reverse engineering. Could you help me please? Where can I get your contact? Thanks a lot. Richard

[@beautyofnature9848]

Thanks for the video
Can we check deviation with STL in creo

[@EngTutorials]

I don't think so. I use GOM Inspect for that

[@beautyofnature9848]

@@EngTutorials
Ok,
Are u working as Reverse engineer