Time Lapse How to: Part out entire 1987 Toyota Pickup Truck/Hilux
HTML-код
- Опубликовано: 14 дек 2022
- This is the final video of the abandoned 1987 Toyota Pickup 22r that I purchased sight unseen. After I got it running in a previous video, I found that the frame was rusted beyond repair. So, today I'm parting out the truck, removing any good parts to help keep other Toyota Pickup Trucks on the road.
Used OEM Toyota Parts: yota.6thgeargarage.com/
I don't have Patreon or ask for donations, but you can support the channel with some rad 'Yota gear from my store: 6thgeargarage.com/merchandise/
Instagram: 6th_gear
6thGearGarage
Some other Toyota videos you may find helpful:
Remove 1980's Toyota Pickup/4Runner Dash Pad Cover: • How to: Remove 1980's ...
Rebuild Front Knuckles: • How to: Toyota 4x4 Sol...
Restore/Fix/Repair a Cracked Vinyl Dash: • Part 2: How to Restore...
Remove Toyota Truck Rear Glass Window: • How to Remove Toyota T...
How to clean/Restore Toyota Pickup/4Runner Door Panels: • How to: Clean/Restore ...
Toyota Door Disassemble: • How To: Disassemble a ...
Rebuild front knuckle & replace birfield joint 80 Series: • Toyota Solid Front Axl...
Remove an Entire Toyota Rear Axle Assembly: • How to Remove an Entir...
Install/Upgrade to V6 1" Master Cylinder on 4 cyl Toyota: • How to Install/Upgrade...
Install Toyota Rear Axle Bearing, Oil Seal - WITHOUT a Press: • Install Toyota Pickup/...
Replace Toyota Drive Shaft Center Support Carrier Bearing: • DIY: Toyota 4x4 Drive ...
Trail Gear Hi-Steer install: • Trail Gear Hi-Steer in...
Toyota Pickup Fiberglass Bed Review/Comparison: • Toyota Pickup Truck Fi...
How to Properly Repair Rusty Frame: • How to Properly Repair...
Repairing Toyota Frame - Cut Out & Replace Metal: • DIY: Repairing Toyota ...
Fixing Floor and Rocker panel rust: • Fixing Floor and Rocke...
Remove Headliner in Toyota Pickup Truck: • How to: Remove Headlin...
Remove Toyota Pickup & 4Runner COMPLETE Dash: • How To Remove Toyota P...
Toyota 22RE Engine Teardown: • $100 Toyota 22RE Engin...
22r Compression Test: • How to: Compression Te...
Remove Toyota 22RE Engine & Transmission: • Remove Toyota Pickup T...
Toyota Pickup/4Runner Vent Window Conversion: • How to: Toyota Pickup/...
Toyota 4x4 Transfer Case Rear Flange Oil Seal Replacement: • DIY: Toyota 4x4 Transf...
Replace Pinion Oil Seal in Rear Diff: • How to Replace Toyota ...
Remove Door Panel: • How to: Remove Toyota ...
LED Headlight Conversion: • How to: Install Toyota...
Repairing Toyota Frame - Cut Out & Replace Metal: • DIY: Repairing Toyota ...
Breaking a Rusty Toyota Frame in Half: • Breaking & Cutting Up ...
B-Pillar Trim Removal & Install: • Toyota Pickup/4Runner ...
How to disassemble Vent Window: • How to: Disassemble Ve... 
Авто/Мото
As someone who parts out rusty Toyotas as well, I enjoyed the video. I would grab the gas door if the hinge isn’t shot. At least grab the lock if the key matches!
Thanks! The key doesn’t match and the door is dented up, or I would have.
Great video as usual 👍
Hi Bryan good trucks
Thanks for video
I am in the carbban
i need the door panel drivers side and the dash
its a shame the aluminum ac lines weren't savable. those are in high demand and they were discontinued by toyota a long time ago.
I did save the one in the engine bay, but the fittings were all seized on the ones by the condenser. I'm surprised nobody is reproducing them... a thin piece of aluminum tube and a couple of fitting would bring a huge profit.
@@6thGearGarage I have actually looked into making new ones. Unfortunately I can't find anyone who sells a tool that can make that stepped flare. At least you saved one of them. The hard to find ac parts for these trucks are the aluminum lines, the compressor manifold, the ac drier mounting brackets and completely evaporator boxes.
Rusty or not... that tailgate probably would look good on your wall. Also your next project may need some bed sheet metal (in the bed) if you have some you can cut out and remove it will save you some hammer forming etc.
Great idea, I just removed the tailgate after reading your post. The bed floor is pretty rusty though.
@@6thGearGarage Nice. Hopefully the next truck has less rust. My 79 comparatively has very little. The reinforcing plates for your body to frame mounts are not sealed from underneath (from the factory). might have to do a little work if some rust jacking pushing up the floor (especially the ones under the seat in the cabin corners. Looking forward to see your work on it.
just got an 89 pickup and i’m super new to mechanic work, what are some common problems for this truck? i’m just looking for resources :) steering is a bit clunky
Adjust the valves. Inspect the timing chain guides, if they are plastic and or broken, then you will need to replace the timing chain.
How many miles and what engine/trans does it have?
Frame rust put drainage holes in the frame so water doesn't build up
@@6thGearGarage 292k 22re automatic
Hey, I need that parking brake handle...mines worn out. Also sent you a message at your parts store...havent heard back?????
Hey I saw your email, I haven't replied because I haven't came across any 4wd indicator lights yet. If I do I will let you know. I'm still working on cleaning, photographing and cataloging parts from this truck, but I did pull the parking brake handle because it was good. I hope to get to that soon!
@@6thGearGarage Thanks...you do have a gold mine of stuff...
@@drewfleming7065 Yeah I've hoarded way too much... now it's taking forever to go through it all.
How much for the dash?
It's currently pending payment... if he doesn't buy it I will put it up in my store.