How do you freeze just the bearing? The cam chain gear holds the bearing on the crank. Is there a good way to pull the cam chain gear off or should i just freeze the whole crank? As for heating the case half, how hot should i set the oven?
Noticed one of the gears had a broken off tooth not sure if I did that somehow or what but do you think it’s not good to run? It’s broken very clean at the bottom of the tooth
To install just heat the case half and freeze the crank bearing. It will fall right in.
thanks for the video man! just got a new lower for 01 raptor..bad 2nd gear. will be replacing it soon.
Great, glad the video helped you. An old Canadian friend taught me that trick.
thank you so much i cant believe it was so easy !
JDM sideways , no problem. I'm glad it helped you!!
Did you ever make a video for installing the crank back into the case half? I'm about to do this on my raptor and I'd love to see how you did it.
Damn bro sucks that you never made me rhe video on installing it
I have never done a 700, but it should be similar. Might want to look for a 700 video just to double check.
Good luck.
How do you freeze just the bearing? The cam chain gear holds the bearing on the crank. Is there a good way to pull the cam chain gear off or should i just freeze the whole crank? As for heating the case half, how hot should i set the oven?
Did you make a video in installing the crank?
Where's the video of you putting it in?
Thanks, I'm about to do my 700. So no special tools? Just heat the case and freeze the whole crankshaft?
Nice video!
Thanks, I hope it helps a few people out!!!
Noticed one of the gears had a broken off tooth not sure if I did that somehow or what but do you think it’s not good to run? It’s broken very clean at the bottom of the tooth