Viofo A139Pro 3Ch Dashcam install - Jeep JL Wrangler

A basic 1 take video explaining how I installed the Viofo A139Pro 3 Ch Dashcam into a 2022 Jeep Wrangler JL with the AUX switchbank, There's plenty of other videos showing trim removal. Watch at the end to see the footage from the camera.
Some key points are :
- Change the fuses to 5AMP for the "Ignition Wire" and the corresponding Aux Switch or the "Battery" circuit if you are going to use that instead of the switch. I used the switch so I could turn it off when parked in my garage so it doesn't unnecessarily record in parking mode and also to prevent drain on the car battery.
- You must have the Aux switch turned on before you start the car. If you start the car then press the switch on, the dashcam will not power up as it won't detect that the car has been turned on. Ensure you set your Aux switch to "Battery" and "Latch" in the vehicle settings Aux switch menu.
- I'm yet to attach the interior camera, however if you do run that the front camera gets reduced to only 4K.