Artillery Sidewinder Thin Wall Printing Setup & Review

I will show tips and tricks for printing thin wall with this Artillery Sidewinder direct drive printer. I also print a full 3D printed RC airplane and give a review on the process.
Spool Holder STL: cults3d.com/en...
Thank you so much for watching!
If you like videos like this, consider buying me a coffee, it really supports me: www.buymeacoff...
See what else I am working on:
/ troymcmillan_rc
/ troymcmillan_rc
#3Dprinted,#RCairplane, #Artillery
Aliexpress store link：www.aliexpress...
Artillery 3d official website: www.artillery3...
STL Files for the ASK14 Glider: www.planeprint...
How to Print Thin Wall: • How to Print Thin Wall...
Thank you to Artillery for sponsoring this video!
*These are the settings I used for this Artillery Sidewinder X1 with Overture PETG. These may not work exactly for you, but should give you a good base to start with if you have a similar size printer. Good luck!
Profile 3 Cura Settings:
Quality:
Layer Height - 0.25
Line Width - 0.4
Shell:
Wall Line Count - 1
Infill:
Infill Density - 0
Material:
Printing Temperature - 240
Build Plate Temperature - 60
Flow - 100
Enable Retraction - Checked
Retraction Distance - 1.3
Retraction Speed - 10
Retraction Extra Prime Amount - 0.2
Speed:
Print Speed - 100
Outer Wall Speed - 35
Inner Wall Speed - 35
Travel Speed - 100
Travel:
Combing Mode - off
Cooling:
Enable Print Cooling - Checked
Fan Speed - 50
Mesh Fixes:
Union Overlapping Volumes - NOT Checked
Special Modes:
Surface Mode - Surface
Experimental:
Slicing Tolerance - Middle
Disclaimer: I am sponsored by some of the products I mention. However, all of my opinions are my own. Thank you for your support!!