SCR 2000W AC 220V Voltage Regulator Motor Speed Controller
HTML-код
- Опубликовано: 4 авг 2024
- how to wiring and reviewing of SCR 2000W 220V AC Motor Speed Controller || Light Dimmer || Universal AC Speed Controller || SCR 2000W 220V AC Voltage Regulator module
s.lazada.sg/s.1Zrt1
Please Subscribe to my Channel 🙏🙏
/ @p9diy583
New Diy Video in my channel;
DIY 12V Mini UPS For WiFi Router ( Backup Time 8 Hour ) || DIY Acrylic Box
• DIY 12V Mini UPS For W...
Thanks just did this on my ducting fan,worked a treat
I'm hearing a loud buzzing noise from my speed controller is this normal?
This is not normal; normally, it shouldn't make any sound.
Very professional work, Thanks my friend ❤️❤️❤👌👌
Thank you Friend
Good, but I think you change something (pot type) or adjustments
My 2400 w vaccum cleaner has similar circuit board. But on tturnibg de speeknob/ potentiometer no variation in de speed ... runs on one speed. Pl guide.
You have to regulate the minimum voltage. You do it by adjust the screw on that blue cube on the left
Is it really controlling speed?
Hello I have unusual question wuld that circuet work with pick up coils found in distributors?
I have for days problems finding corect circuet to interupt pick up coils going to ignition module .
So any help please?
Can this be used with PTC heating element?
Sir, ek sath 6 bulb(100W) ka video banao pls 🙏🙏🙏🙏🙏🙏🙏🙏
Yes u can
Bhaisahab is se 1 kw ka single coil stove control kar sakte hai kya ,stove ko 100 degrees Celsius par chalana hai
Sir ek sath 6 bulb(100W) ko control kar payega yeh controller
Can i use this for my 110v heatpress?
Please i want the diagram of board and part series used on it !
Can I connect this to 500w pumping machine to increase voltage
can we give input as DC volt ??
No . This is a Ac voltage regulator ,If you want to use DC, use a DC voltage regulator
cab i use this dimmer with food processor
Dove si compra? Mi interessa
How to connection motor capacitor & speed controller
Please help me out. The motor just vibrate and wont rotate? what should i do? I already did everything i could even changing the wire polarity, the ac motor is 220v and the speed controller is just same as yours
How many Watts is your motor? Single phase motor? Does the motor run when running directly on AC 220V without a speed controller? In motors, the starting load is 3 times more than the running load. If your motor is 1000w, then the speed controller will use 4000w.
@@p9diy583 so we can only use motors with power of 1/3 of the rated w of controller
What if the motor of my bandsaw is 220watts can i use this speed control?
KA itu arus listrik nya langsung dari listrik rumah
This dimer bord available in Amazon.
Yes available on Amazon
Hello .. can i use with on a fan ventulation 220v 18 watts ?? Plz need it asap
Just connect the Line connections, input and Output
But the LED lamp that I use to operate the module I installed is constantly blinking except for high and low levels.
This dimmer is not for led lamp. You can use dc dimmer for led lamp
mine was working but now it is not effecting the speed of the motor anymore.
Output me dc voltage milega ya ac voltage???
AC Voltage
The motor speed is maximum
Speed is not changing
I have changed the scr (bta 16)
One question, when we use a motor with a pwm, will the motor get hot?
Can i use this in 5 HP electrict motor tnx
Cannot be used on 5hp motors
Use in 0.5 hp water pump?
2hp tak chala sakte hain but 1500w ke niche
@@ranjitbhowmick4381ଧନ୍ୟବାଦ 🙏
😊😊😊😊😊😊😊😊
Bhai diwali pe rice light jhalar me lagata hu to kuch jhalaro ke ek do bulb jal jate hai jyada voltage ke karan
To kya kiya jaye jara bataye
Kya jhalaro ke liye voltage ko regulator se Kam karke unke bulb ko jalnese roka ja sakta hai 🤔🤔🤔🤔🤔
Yes, it is possible to prevent the bulbs from burning out due to excess voltage by using a voltage regulator. Adjusting the voltage regulator to lower the voltage supplied to the rice lights can help ensure that the bulbs do not receive too much power, which would prevent them from burning out. Make sure to set the voltage to a level that is safe for the bulbs.
No, its current control, not the voltage. If you remove the output (lamp), check the voltage with multimeter... It will not change. So it's not voltage controller, its a dimmer (current controller)
And so??
Voltage will drop when connecting even a small load though. The go ahead and measure
More accurately it's average current. If a device normally takes 1A at 220V, it will still take 1A at 220V if "dimmed" with a 25% duty cycle using this device, but only for 25% of the time.
Excetly
Is that why my 4 kw identical version was reading low voltage when hooked up to my treadmill motor and went up to 240 volt? It's a voltage regulator.
Can we use 850 watt
Yes can be used
Please check if streight grinder is running on this device
I don't have straight grinder yet, I will check with straight grinder later and let you know.
@@p9diy583 thanks for reply
I m waiting for u r reply. Becouse I have one, want to reduce the rpm
Ok, i will let u know once i have it.
This use for 1550w heater
Kya is se 1 kw ka heater control kar sakte hai kya
not convenient to use for water heater
I need it's name specification and where to get it
This is a high-power electronic voltage regulator, work power 2000w, generally can be used to adjust the voltage, adjust the light, adjust the small motor speed, or adjust the temperature. In the case of access to the load, we can use it to adjust the AC voltage, adjust the range from AC50V to AC220V
Bro I connected this regulator to my water heater (780wat) and heat sink is getting very hot. Is that normal? Plz reply
The water heater has a high Ampere, which is not convenient to use
The water heater has a high Ampere, which is not convenient to use
What is that called
SCR 2000W voltage regulator
price
1 for US$4.86 on Banggood
Hello Sir,
Can you mention from where we can purchase this speed controller??
Available on Amazon and flipcart
Check description
Sakin Yung 100v na grinder ko parang lalong bumilis
If you're going to use a 100V grinder, reduce the voltage before connecting the dimmer. Without reducing it, the maximum voltage will be 220V. If you're not careful, it can burn out.
You should adjust the blue potentiometer to ensure the maximum voltage is set to 100V before using it.
What is the price.
About 1.96$ - 2$
Capacitor 105 J 630V
Can use or not.
Where is Capacitor 105 J 630V used?
কোথায় পাবো
Please check in description
ruclips.net/user/shorts20U1Mnima0g?si=GriazHgV0wLOm5Iz
Tolong cara memasang nya gimaa ya,,soallnya akuu nyalakan konSlettt 🙏🙏🙏🙏
Its not SCR......TRIAC......
means ? kindky eloberate
doing pwm, no frequency adjustments