11-6 Design of beam and shaft| Mechanics of Materials RC Hibbeler
HTML-код
- Опубликовано: 11 сен 2024
- 11-6. The spreader beam AB is used to slowly lift the 3000-lb pipe that is centrally located on the straps at C and D . If the beam is a W 12 * 45, determine if it can safely support the load. The allowable bending stress is s allow = 22 ksi and the allowable shear stress is tallow = 12 ksi.
Dear Viewer You can find more videos in the link given below to learn more and more Video Lecture of Mechanics of Materials by Beer & Jhonston
• Mechanics of Materials...
215 Problem solutions of all chapter of Mechanics of Materials by Beer & Jhonston
• Mechanics of Materials...
Chapter 4 of Mechanics of Matereials rc hibbeler (09th Edition) • Chapter 4 (Axial Loadi...
Chapter 3 of Mechanics of Matereials rc hibbeler (09th Edition) • CHAPTER 3 MECHANICAL P...
Chapter 2 of Mechanics of Matereials rc hibbeler (09th Edition)
• CHAPTER 2 STRAIN, MECH...
Chapter 1 of Mechanics of Matereials rc hibbeler (09th Edition)
• CHAPTER 1 STRESS- INTE...
#mechanicsofsolids #strengthofmaterialstutorials #mechanicsofmaterials #bendingmomentdiagram #rchibbeler #solidmechanics
What is the total result force trying to compress the beam: 2700 lb or 2 x 2700 lb = 5400 lb?
single value of px=2700 and both are 5400
Great Video, thank you for uploading it. Can you please make videos on Shingley's Mechanical Engineering Design?, In particular on failiure theories?
ruclips.net/video/lJ3362N29kk/видео.html
This is the link of lecture related to failure theories. I hope you will enjoy it.
Also share my channel in your community to get maximum crowd....Thank you so much for your valuable feedback 👍
@@engradnanrasheedmechanical Thank you so much for uploading these videos. You are a lifesaver.
Hahahahahaha keep sharing and learning.....
Did you watch the lectures of failure theories?
thats P is 3084 ,thats value is for both or each?
The value of P is for each side....
where did you get 58.1 from ? A chart?
Yes. Kindly check the video it is mentioned in that. You have to go at the end of book and look for the table for section modulus S....