Nickel brush plating

[@2FRESH-4U]

Oh man I’m going to have to try this on a countertop I’m working on I sanded through the plating and it’s all installed into the marble island I’m kinda freaking out but I’ll give this a try thanks for the video

[@superjojo555]

hello there, how did it turn out? did u manage to re plate your countertop?

What was best voltage/amps settings to achieve best results?

[@llimo4382]

Nice video. What did you use for the electrolyte? Thanks.

[@peterpereszlenyi]

Thanks, vinegar and kitchen salt solution was used to make electrolite.

[@llimo4382]

@@peterpereszlenyi Thanks. Can you tell me what you used on the tip of the anode? Thanks again, Peter.

[@peterpereszlenyi]

@@llimo4382 it is piece of medical bandage. I tried it as I had it laying around :)) I think anything soft that soaks electrolite well will work fine.

[@llimo4382]

@@peterpereszlenyi Thanks. I wasn't sure if I had to worry about using something that might shed. Thanks again

[@trym2121]

​@@peterpereszlenyi Hi, what did you use for the nickel source before diluting in electrolyte? Nickel salt (chloride or sulfate)?

[@brunoburtoni8479]

Never knew you can use a nickel anode most are graphite or platinum ?

[@K7classicrockfan]

Does this work on a steel car bumper? Thanks.

[@peterpereszlenyi]

It does work on steel as well

[@K7classicrockfan]

@@peterpereszlenyi thank you!

[@andreasmahmudi-dz5mv]

Bang mesin brush posting merk apa ya bang❤

[@JohnnySteam]

👍