when set to that mode, the multimeter will measure voltage drop across the leads (similar to resistance measuring mode). also it'll beep when the voltage drop (or resistance) across the leads is very low, which means a short circuit. it's used to test if wires are properly connected, or to find out connections in PCBs, etc.
You can use this function of the meter to measure capacitors and coils using the formulas x=1/2(3.1416)(Frecuency)(inductor or Capacitance)
No, this formula is applicable only for sine wave
Thanks sir
Thanks brother good explanation ❤
Thank you
excellent explanation congratulations, and I searched for this topic on youtube and this is the first time that someone explains it with quality.
thank you so much...
😂 loved it. Was a fun and informative video.
thank you. please subscribe
Fine. Thank you. Keep going.
Thank you!
Good job!
thank you...
well done
thank you.
Se não fosse esse cara, eu nunca ia saber os detalhes dessa função.
english please.
cut ur nail bro
I still dont understand what this is for... I understand what iot does, but what is it used for.... why does a person need this function?
Same. I understand what it does, but I can't figure out for the life of me, why it does it.
What about the symbol to the left of that one? That shows radio waves
that one is for checking diode, led and continuity.
when set to that mode, the multimeter will measure voltage drop across the leads (similar to resistance measuring mode). also it'll beep when the voltage drop (or resistance) across the leads is very low, which means a short circuit. it's used to test if wires are properly connected, or to find out connections in PCBs, etc.
you still did NOT say what is it USED FOR?
please watch the full video to know
Still don't know its uses........
please watch the video to know
no please fucking you did not explain what it's actually used for
and cut that gross fingernail@@RGInnovations
Flush the loo