Honestly, just taking your time and double check everything before you start cutting. To make sure i understood what i was doing I read the book twice before starting. I then re-read the section i was about to attempt to make sure i was clear on the instructions.
It's a Bernzomatic TS8000 torch head and I'm using MAPP gas. I purchased it at my local Home Depot, but here's a link to amazon for the torch head. amzn.to/3pOczRl
Very cool, however they quit making MAPP gas in 2008 so unless you have an old cylinder of it you’re using MAPpro, which doesn’t burn as hot. Also unless you’re mixing it with oxygen then you’re soldering not brazing.
I built two frames using the book and video by Chimonas . 5 years ago. Ride them all the time.
Came out great.
Thats awesome!
Great job, thanks for posting. May I ask why you did not use stainless steel tubes?
I bought same book thank you for explaining. I have no knowledge on braising and mittering I hope I can do it. What do you advise me before start.
Honestly, just taking your time and double check everything before you start cutting. To make sure i understood what i was doing I read the book twice before starting. I then re-read the section i was about to attempt to make sure i was clear on the instructions.
Where to buy all the parts?
How to buy luggs
Is that a propane torch you're using?
It's a Bernzomatic TS8000 torch head and I'm using MAPP gas. I purchased it at my local Home Depot, but here's a link to amazon for the torch head. amzn.to/3pOczRl
Very cool, however they quit making MAPP gas in 2008 so unless you have an old cylinder of it you’re using MAPpro, which doesn’t burn as hot. Also unless you’re mixing it with oxygen then you’re soldering not brazing.