This car has the battery in the back .. so it was a easy install .. it’s the same wiring.. just that the box I installed with the inverter.. just run the power wire to your amp and the inverter with the rca to the amp.. it will work
@@TheoHyatt On the instructions manual it shows two pairs of speaker wires going into the sub (by cutting off the RCA connectors), why would the sub need two pairs of speaker wires going - wouldn't one pair of speaker wires be enough, It not like the sub runs in stereo - it's mono right?
Hi I have a similar car but it not the evo… just a lancer. Please can you let me know where is the accessories fuse located? Or send me a picture so that I can run the remote wire through it ??
Your gonna need a audio converter.. so you can tap into door speaker wire .. and a power and ground wire .. plus a remote wire from ignition fuse to amp
Hey bro can you link the amp wiring kit you used? And one question how did you hook up the small wiring harness cables from the subwoofer to the big cables? Cheers! 😊
DJ Tech Pro USA, LLC Pioneer TS-WX1010A 10” Sealed Enclosure Active subwoofer with Built-in Amplifier www.amazon.ca/Pioneer-TS-WX1010A-Enclosure-subwoofer-Amplifier/dp/B0794YHK5M/ref=asc_df_B0794YHK5M/?tag=googlemobshop-20&linkCode=df0&hvadid=292993312789&hvpos=&hvnetw=g&hvrand=1621661962996762539&hvpone=&hvptwo=&hvqmt=&hvdev=m&hvdvcmdl=&hvlocint=&hvlocphy=9000092&hvtargid=pla-685355239912&psc=1#
@@TheoHyatt Aye thanks. Also, you can just strip the wires from the harness and wrap that around the cables from the kit then tape it right? I'm sorry for asking a lot its my first time installing it. 😓😂
I have this ....pioneer 1210 In my mpv.... Set to 40 Hz .. Nice and low Bass volume on 8 .. I hits ....nice ... Sounds clear Well i have Focal 5#7 inch On the doors... This single sub in the back Goes hard .... Well better than factory bs Anyway 😊
Can you tell me what settings you do on your pioneer active subwoofer TS-WX1210A from side panel… As mine one blew for 2nd time If you can share it will be helpful What’s the maximum limits we can do on this
I bought new one from amazon, it came dead, wired everything like on paper and nothing. Power led never lit, wire from battery was giving 12v, ground to the car bolt, blue remote wire to 12v antenna from head unit(tried direct to battery as well after) and nothing, not a flicker in led. Very disappointed, as was excited to get some bass from Pioneer… Refunded, now looking for another one, would try this again, pretty sure does the job, but quite worried if same sh&t happens.
Nah… only if it’s a aftermarket head unit.. but the stock head unit doesn’t come with rca outputs.. and it’s easier to wire the system with line output converter..especially if your financing the car too .. no screwing touching of the deck
@@awolpw70 I did make a mistake tho , the box I installed came with a built in line output converter.. which I found out after installing the system lol
Did it make your existing speakers sound better? Or handle bass better? How was before n after
Better.. existing speakers balance was adjusted from radio . More power to front door mids
Hey quick question does your power light stay on when the car off?
Nah.. connect the remote wire to the ignition fuse .. so it comes on wen ignition is on
Yo I have a Rockville 10” 500 watt and I want to replace it with this doesn’t look like the wiring to the amp is the same. How did you wire this ?
This car has the battery in the back .. so it was a easy install .. it’s the same wiring.. just that the box I installed with the inverter.. just run the power wire to your amp and the inverter with the rca to the amp.. it will work
@@TheoHyatt alright thanks… how powerful would this be compared to 500 watts?
Ohh you want switch the rockvil 10 to the pioneer box I installed in the video ?
@@TheoHyatt just wondering how much more power comes from 1300 watts instead of 500 watts
@@mf_ranger864 a lot more .. you will hear less speaker baffle.. under power cause speaker to baffle a lot
Just a fyi mate you actually don’t need to use a line out converter the amp itself already has speaker level input instead of rca you can use either
So true lol.. we had the line output converter so we just add it into the line for shyts and giggles
So what’s the easiest way to hook it up?
Just tap into one of the speaker wires and run it to the box
@@TheoHyatt On the instructions manual it shows two pairs of speaker wires going into the sub (by cutting off the RCA connectors), why would the sub need two pairs of speaker wires going - wouldn't one pair of speaker wires be enough, It not like the sub runs in stereo - it's mono right?
Hey so did u have to connect it to the battery and ground it out?
The battery was in the back of the car , so I connected the ground on the negative side of the battery .
did you have to put a fuse between the power cord from the car battery to the connection in the amp?
It’s recommended but you can run it without the fuse , just know that if there’s a shortage in the circuit your amp will burn ( damage)
Always run a fuse after the battery no more than a foot (12”) at-least a 40 amp
Hi I have a similar car but it not the evo… just a lancer. Please can you let me know where is the accessories fuse located? Or send me a picture so that I can run the remote wire through it ??
Number 13 slot 15 amp fuse above your pedals
Hi I am installing this today . Do I need a output converter?
No need.. the box comes with a built in one I think ..
Hey I have the same sub but what else all do I need for the install?
Your gonna need a audio converter.. so you can tap into door speaker wire .. and a power and ground wire .. plus a remote wire from ignition fuse to amp
Hey bro can you link the amp wiring kit you used? And one question how did you hook up the small wiring harness cables from the subwoofer to the big cables? Cheers! 😊
DJ Tech Pro USA, LLC Pioneer TS-WX1010A 10” Sealed Enclosure Active subwoofer with Built-in Amplifier
www.amazon.ca/Pioneer-TS-WX1010A-Enclosure-subwoofer-Amplifier/dp/B0794YHK5M/ref=asc_df_B0794YHK5M/?tag=googlemobshop-20&linkCode=df0&hvadid=292993312789&hvpos=&hvnetw=g&hvrand=1621661962996762539&hvpone=&hvptwo=&hvqmt=&hvdev=m&hvdvcmdl=&hvlocint=&hvlocphy=9000092&hvtargid=pla-685355239912&psc=1#
www.amazon.ca/Pioneer-TS-WX1010A-Enclosure-subwoofer-Amplifier/dp/B0794YHK5M/ref=asc_df_B0794YHK5M/?tag=googlemobshop-20&linkCode=df0&hvadid=292993312789&hvpos=&hvnetw=g&hvrand=1621661962996762539&hvpone=&hvptwo=&hvqmt=&hvdev=m&hvdvcmdl=&hvlocint=&hvlocphy=9000092&hvtargid=pla-685355239912&psc=1#
The small wiring harness comes Color coded , it will tell wat wire is speaker , remote , ground and power
@@TheoHyatt Aye thanks. Also, you can just strip the wires from the harness and wrap that around the cables from the kit then tape it right? I'm sorry for asking a lot its my first time installing it. 😓😂
No prob bro ,, ask as many questions, it’s y I make videos 👌👌
I have this ....pioneer 1210
In my mpv....
Set to 40 Hz ..
Nice and low
Bass volume on 8 ..
I hits ....nice ...
Sounds clear
Well i have Focal 5#7 inch
On the doors...
This single sub in the back
Goes hard ....
Well better than factory bs
Anyway 😊
Can you tell me what settings you do on your pioneer active subwoofer TS-WX1210A from side panel…
As mine one blew for 2nd time
If you can share it will be helpful
What’s the maximum limits we can do on this
How did it blew ?
@@TheoHyatt I don’t know…
When i bought it back for warranty claim they said you are playing it on high bass that’s why
I bought new one from amazon, it came dead, wired everything like on paper and nothing. Power led never lit, wire from battery was giving 12v, ground to the car bolt, blue remote wire to 12v antenna from head unit(tried direct to battery as well after) and nothing, not a flicker in led. Very disappointed, as was excited to get some bass from Pioneer… Refunded, now looking for another one, would try this again, pretty sure does the job, but quite worried if same sh&t happens.
Shhhssss🥴🔥🔥🔥🔥
🔥🔥
is the power connector supposed to click in? i just push it in but could also just pull it out without using the tab. it’s not powered on
Yeaa , clicked in lol
Which song ?
The intro ?
Don't you just run the wires and rca to the Headunit? Simple
Nah… only if it’s a aftermarket head unit.. but the stock head unit doesn’t come with rca outputs.. and it’s easier to wire the system with line output converter..especially if your financing the car too .. no screwing touching of the deck
@@TheoHyatt True 👍 but i took the stock unit out so it was easier for me. Good install for you tho.
@@awolpw70 I did make a mistake tho , the box I installed came with a built in line output converter.. which I found out after installing the system lol
Hey bro, did you run it in before turning it up loud?
@@awolpw70 what you mean ?