6 Point Harness Install in the FRS
HTML-код
- Опубликовано: 23 авг 2024
- We're finishing up on the inside of the FRS today with a 6 point harness install. We also need to put back some of the interior to clean things up and to abide by the rules set by Gridlife to run ClubTR. The harness is going to hold us in a whole lot better than the stock 3 point so I won't have to worry about bracing myself in the seat while driving.
Racequip 6 Point Harness: www.racequip.co...
Autopower Roll Bar: www.autopoweri...
Recaro Profi
Current Setup
Verus Engineering UCW Rear Wing
Verus Engineering Composite Front Splitter
Verus Engineering Air Dam
FT86SpeedFactory UEL Header
Verus Engineering Hood Louvers
Perrin Oil Cooler
Stoptech C43 Big Brake Kit
Hawk HP+ Pads
Verus Engineering Brake Cooling Kit
Apex EC-7R 17x9 +35mm
Bridgestone Potenza RE-71R 245/40/17
Rays Gram Lights 57CR Ceramic White Pearl 17x9 +38
Falken Azenis FK510 245/40/17
Remark R1 Spec Titanium Catback Exhaust
Tomei Front Pipe
Motiv Overpipe
Recaro Profi SPG
Buddy Club Super Low Down Seat Rails
Helix Depo K Shade Tail Lights
17+ Instrument Cluster w/ Digital Display
Gerald Just Projects Cluster Retrofit Kit: tinyurl.com/2p...
Instagram: / v
Best tutorial how to install harness and mounting points so far, nice!
Glad you found it helpful!!
You make me wanna do a setup like this on my frs on of these days for the track 😮💨
Do it!!!!! Can't really drive the car on the street now though haha
Definitely best tutorial for harness mounting points!!!
Very clean job man. Super super clean.
Appreciate the kind words Peter!!
Awesome video dude
Thanks dude!! You're next!
Solid video, thank you!
what was the thread pitch for the eye bolt that u threaded into for the stock 3 point seatbelt location
Am I the only one wondering how that big washer and nut went into that small hole in the frame rail?
There was a slot just big enough for me to slide the washer through.
Great video kid! 🤣. How long do you think this would take, start to finish, if a normal person had to do this?
Thank you thank you! 😅 I am a normal person what are you talking about?! haha if I didn't have to film the project and didn't have to wait for the powder coating on the roll bar I could've gotten this done in a weekend as long as my welder was available.
@@KevinVo No you're a super hero! But actually I was thinking without having to film and stuff.
Track days coming up!
When are you going to swap in that FA24 engine?
haha maybe in a few years 😅
Is this the same method in installing the 5 point harness as well? Thanks
Yes same process!
@@KevinVowouldn’t the fuel lines get in the way?
@@dmw_99 I was able to sneak in between them.
7:08 *sighs* “THAT IS TIGHT!!! Oh I really gotta be careful not to pinch my wiener in there”
I’m doing the same install, just curious as to if it is necessary to anchor the shoulder harness after wrapping it around harness bar?
Wrapping it around the harness bar is the anchor.
Did you need to plug a resistor for the Yellow Airbag Connector that the factory 3 point plugs into?
Yes I did
@@KevinVo which ones?
Heyo! Question, did you use a locking collar to keep the harness from sliding? If so which one?
Yes, I used some ASR collars.