Apparently you are not meant to wash the bin bit because if any of the left over water gets into the machine part while using, it can seize the whole thing. I was told to use a mild disinfectant spray to clean it.
I also got taught by dyson to tap the inside silver canister with a wooden spoon outside when u remove it from the plastic bin to remove all the dust caught up inside the unit. it's amazing how much comes out
Guys, why not dismount this metal grill from time to time? Lots of dust deposits gather there. Once you remove them, your dyson stops stinking on the exhaust. Just be careful not to break the plastic fasteners.
@@akakiy60I’m telling you bro go with a air gun hose , remove the rear filter and blow into the area where the pre filter sits it will blow the dust out the unit
J'ai lavé délicatement le récepteur de poussière et le joint rouge ainsi que le rond en métal se sont décollés. Impossible de les replacer correctement. Je vais être obligée d'acheter un nouveau conteneur de poussière ?
@@lyykuppi other videos I watched dusted the seal with baby powder and it made it slide open easier. Part of the red latch broke that stopped it from sliding but it still works
Yeah baby powder works great 👍🏻 in our case, the plastic holders broke from the bottom and it stopped working (not sure I remember the place correctly).
I used ispropyl alcohol 70 % n all that crap stuck came right off made it look like new, every month u just got to give it a little dust off n clean with a cloth n deep clean it every 6months or a year
Thanks a lot. You saved me, mein today after few minutes in spite of was charged, stop to work. Then I did according to what you did. It's Dyson glide. 🙏
I wish you could wet the head part, not just use a tooth brush to clean it. A friend of mine decided to clean up vomit with my Dyson I had just bought a week prior and it’s still has “stains”. I hate it.
Urs was ok mine was like filth from gutters 😂 but i did clean it was some other vaccum even it started smelling bad and then i got to know okbit was the vaccum
I took my canister completely off and when trying to put it back on the red seal at the base detached and the retention ring also came off and no matter what I tried it will not stay on any more.
this happens to a few people, and its because there is a stopper at the end of the runner and if it breaks it will need to be replaced. hope that helps.
Very satisfying to watch.
Awesome! I didn’t know you can completely take it apart and clean my Dyson like this. Thanks ❤
I'm glad you found the video helpful!
The video I’ve been searching for 🙌🏼
You're welcome 👌
LOVE YOU!! Thanks for this video🙏🏼🙏🏼🙏🏼
You are so welcome! Thank you
Apparently you are not meant to wash the bin bit because if any of the left over water gets into the machine part while using, it can seize the whole thing. I was told to use a mild disinfectant spray to clean it.
Use a seam ripper for the hair rolls on the axels. They come off in seconds.
Wow superb work❤❤
Thank you so much 😀
🤩perfect 🤩🤩🤩
Never use carpet freash I work a dyson and number 1 reason for moter failure is baking, soda, carpet, fresh, exetra
Oh really. Thank you for the tip. I'll be sure to add that into my video
Claire nette précis merci !
You're Welcome
May you come clean mine now please!
All you have to do is take care of the shipping charges. I'll do the rest, no charge😀
I also got taught by dyson to tap the inside silver canister with a wooden spoon outside when u remove it from the plastic bin to remove all the dust caught up inside the unit. it's amazing how much comes out
Awesome I will do so next time👌 Thank you
That’s where the cyclone assembly is I always use an air hose to blow all that out
Guys, why not dismount this metal grill from time to time? Lots of dust deposits gather there. Once you remove them, your dyson stops stinking on the exhaust. Just be careful not to break the plastic fasteners.
@@akakiy60I’m telling you bro go with a air gun hose , remove the rear filter and blow into the area where the pre filter sits it will blow the dust out the unit
Does the canister stick? I thought water removes the lubricant on the seals? Or did you dust them with talc after? It looks nice and clean :)
The canister opens and seals perfect, like new. It was gently washed and dried thoroughly
J'ai lavé délicatement le récepteur de poussière et le joint rouge ainsi que le rond en métal se sont décollés. Impossible de les replacer correctement. Je vais être obligée d'acheter un nouveau conteneur de poussière ?
We had it broken because it got sticky. Had to buy a new canister. So don't wash the canister with water.
@@lyykuppi other videos I watched dusted the seal with baby powder and it made it slide open easier.
Part of the red latch broke that stopped it from sliding but it still works
Yeah baby powder works great 👍🏻 in our case, the plastic holders broke from the bottom and it stopped working (not sure I remember the place correctly).
I registered buying stick vacuum. Oppsss high maintaining..
👍
quel travail, un aspirateur c'est tellement MIEUX et bien plus puissant !
Yes, it's always way better after a clean💪 thanks for watching
Which Dyson do you recommend? We have pets, tile/wood floors & we would like to use it in the car. Any thoughts? Thanks!
This one is great, the V11 absolute. But the V15 is a little more powerful, and the battery is better. But it's gonna come down to your budget👌
❤❤❤❤
Thank you for watching😁
I used ispropyl alcohol 70 % n all that crap stuck came right off made it look like new, every month u just got to give it a little dust off n clean with a cloth n deep clean it every 6months or a year
Awesome thanks for the tip! Will try it.
If you get it wet with running water Don’t forget to spray WD40 in the brush and motor head bearings.
Thanks a lot. You saved me, mein today after few minutes in spite of was charged, stop to work. Then I did according to what you did. It's Dyson glide. 🙏
That's great. I'm glad it worked out for you🙏
myjesz pod wodą papierowy filtr? Nie rozpadnie się?
I've washed it a few times, and it's still going strong. Just be sure to let it dry completely
⭐️⭐️⭐️⭐️⭐️
Don't use water to clean the bin! The dust is meant to stay in the rjng in order to lubricants it. I jusr found this out front a dyson expert
Thank you for the tip 🙂
Que pasa si sumerges rodó en agua en plan lo del pie k limpia el suelo
It will damage the machine, as the water will go into the motor
How did you put brush back on? Mine keeps come out
Did you make sure the end cap locked
I see the toothbrush but what is the other item you are using to clean the hoover please
It's a standard nylon brush, tweezers, microfiber cloth and can of air💪😁
@@handycoco8456 thankyou 😊
I don’t think I ever let my Dyson filter get that dirty
Mine gets like that every 2 -3 months😵💫
Then don’t use your vacuum
@@handycoco8456 you should be cleaning that filter every month
👏🏾👏🏾👏🏾
Thanks LCD is not working anymore
I wish you could wet the head part, not just use a tooth brush to clean it. A friend of mine decided to clean up vomit with my Dyson I had just bought a week prior and it’s still has “stains”. I hate it.
Oh no o so sorry.. 😢 have to tried getting it serviced by Dyson?
Fire your friend.
You can remove the motor from the body and the head and disassemble every single part and wash them all with water, this isn't a deep clean
Dyson don't show this in their adverts. I've gone back to bagged machines, its much cleaner and less work.
I still love this machine💪
I switched to a corded Miele. My battery died and I didn’t want to pay $200 CAD for a new one
Toz haznesinin suyla yıkanmaması gerekiyor
I've been doing it for years, and not one issue.. just make sure you leave it to dry properly for at least 24 hours
Urs was ok mine was like filth from gutters 😂 but i did clean it was some other vaccum even it started smelling bad and then i got to know okbit was the vaccum
🤣🤣 Shame man! hope it worked out... thanks for watching @navjotkaur1956
@@handycoco8456 to my surprise it did 🤣🤣🤣
@navjotkaur1956 Glad to hear it😁
If Dyson is like other vaccum. Don't use it to pick up wet or dry plaster after sanding a wall... Before painting. just a hint 😉😊
cuesta mas limpiar el aparato que la casa…
Just a bit of elbow grease. 😉 It costs so much, so you might as well keep it running smooth
I took my canister completely off and when trying to put it back on the red seal at the base detached and the retention ring also came off and no matter what I tried it will not stay on any more.
this happens to a few people, and its because there is a stopper at the end of the runner and if it breaks it will need to be replaced. hope that helps.
@@handycoco8456 I replaced the seal and retentions ring I got it off Ebay as once piece already assembled
What's the black brush you use to clean the actual brush roll ? Aha
It's just a standard thick nylon brush
You missed a spot
Where?😵💫
@@handycoco8456😂