Размер видео: 1280 X 720853 X 480640 X 360
Показать панель управления
Автовоспроизведение
Автоповтор
great work!!
Reaming the copper, nitrogen brazing, standing pressure test?
What is the purpose of the panel u guy screw in on the ceiling panel in front of the evaporator coil???
It was there, so we assume customer trying to reflect cold air away from the door. We left it there.
How much for the lifting device? Thank you
I think around 100$/day
Don't you like the pipe bending springs? Since I've discovered how to use them properly I save a lot of fittings. (External springs).
I don't like them. We are very small company with very limited time to learn new technics. Way too busy, but once we get there...will try all that exist. thanks for input!
Get the hilmor pipe bender, I’m a small company too and believe me it helps us the most, in terms of time saving. Pays for itself, try it!!
@@edgardelgado9937 I can't bend 7/8" with it.?!
I have bender up to 1/2", love it, don't use it that often tho
Marat RPM SoCal yes you can bend up to 7/8, as well as 3/4.
It was probably so tempting just to chuck that old compressor off the building, lol
)
good job well done!
Buen trabajo
good night marat this application you one is to mark the time of service and the amount to be paid
Great install, you are almost to the point that you might have to hire a another technician.
Right on point. We about to start hiring👍
241 or 133
241 and slightly 133)
great work!!
Reaming the copper, nitrogen brazing, standing pressure test?
What is the purpose of the panel u guy screw in on the ceiling panel in front of the evaporator coil???
It was there, so we assume customer trying to reflect cold air away from the door. We left it there.
How much for the lifting device? Thank you
I think around 100$/day
Don't you like the pipe bending springs? Since I've discovered how to use them properly I save a lot of fittings. (External springs).
I don't like them. We are very small company with very limited time to learn new technics. Way too busy, but once we get there...will try all that exist. thanks for input!
Get the hilmor pipe bender, I’m a small company too and believe me it helps us the most, in terms of time saving. Pays for itself, try it!!
@@edgardelgado9937 I can't bend 7/8" with it.?!
I have bender up to 1/2", love it, don't use it that often tho
Marat RPM SoCal yes you can bend up to 7/8, as well as 3/4.
It was probably so tempting just to chuck that old compressor off the building, lol
)
good job well done!
Buen trabajo
good night marat this application you one is to mark the time of service and the amount to be paid
Great install, you are almost to the point that you might have to hire a another technician.
Right on point. We about to start hiring👍
241 or 133
241 and slightly 133)