How to remove a large spline hub adapter from a Mk3 Volkswagen vehicle. Great to use on a small spline Mk2 or other small spline VWs. Check out: lucidautowerks...
I’m going to install a 2016 camaro steering wheel in my 88 camaro this video just showed me how to adapt the two, thanks I didn’t know that part was removable👍🏾👍🏾
First of all thank you very much for your time and for the video, it is explained perfectly, very good job!! Could you tell me where did you buy this tool? I have to take out the steering column in my car and I will need it. Kind regards!
I bought the tool as a kit from Harbor Freight. Are you doing an ignition switch? There is another way to do it that in my opinion is easier. Remove the steering wheel, remove the one shear bolt on the ignition housing, remove the nut and bolt at the base of the column (top one by the pedals) that attaches the column to the steering joint and slide the inner part of the steering column out of the tube. Then you need a small precision screwdriver and you can get to the screw that holds the ignition switch in. When reinstalling just pay attention to the groove at the base of the steering column by the splines because there is only one way to put it together so that the bolt can pass through the steering joint. Hope that helps.
Have a question hope u answer!!!! My problem is that the pin that comes out of the window elevator where the window handle holds broke can it only be replaced or does the whole elevator needs to be replaced
I’m going to install a 2016 camaro steering wheel in my 88 camaro this video just showed me how to adapt the two, thanks I didn’t know that part was removable👍🏾👍🏾
First of all thank you very much for your time and for the video, it is explained perfectly, very good job!!
Could you tell me where did you buy this tool? I have to take out the steering column in my car and I will need it.
Kind regards!
I bought the tool as a kit from Harbor Freight. Are you doing an ignition switch? There is another way to do it that in my opinion is easier. Remove the steering wheel, remove the one shear bolt on the ignition housing, remove the nut and bolt at the base of the column (top one by the pedals) that attaches the column to the steering joint and slide the inner part of the steering column out of the tube. Then you need a small precision screwdriver and you can get to the screw that holds the ignition switch in. When reinstalling just pay attention to the groove at the base of the steering column by the splines because there is only one way to put it together so that the bolt can pass through the steering joint. Hope that helps.
Have a question hope u answer!!!! My problem is that the pin that comes out of the window elevator where the window handle holds broke can it only be replaced or does the whole elevator needs to be replaced
I believe you have to replace the whole thing. They are cheap on ebay. Front door is the same regulator (elevator) for 2-door and 4-door.
@@LucidAutowerks thanks for ranking the time to reply
Where i can buy that tool?
I bought the bearing splitter in the video at Harbor Freight