Hi. I'm not a welder but been watching your videos. I could see at 6:12 the previous pass was still glowing red then you started a new one without removing the slag. I've seen other welding youtube channels and they always remove the slag after a pass. What's the reason you didn't remove it?
@@jamesward5721Depends on what kind of wire you’re using. Yes there could be slag with a mig weld. Inner shield wire with 75/25 (stargon) carbon dioxide produces slag. Just your basic flux core wire produces slag.
Hi. I'm not a welder but been watching your videos. I could see at 6:12 the previous pass was still glowing red then you started a new one without removing the slag. I've seen other welding youtube channels and they always remove the slag after a pass. What's the reason you didn't remove it?
It's a MIG weld, there isn't any slag produced/used/involved.
@@jamesward5721 oh i see. thanks.
@@jamesward5721Depends on what kind of wire you’re using. Yes there could be slag with a mig weld. Inner shield wire with 75/25 (stargon) carbon dioxide produces slag. Just your basic flux core wire produces slag.
@@dikhurtz2406 flux core isn't mig, just saying like.. mig is metal inert gas... flux core not use gas.. so flux core is just flux core. :-)
@@jamesward5721 I thought you were just saying “mig” as in wire feed. But now I can see you know what you’re talking about.
面白くて見入ってしまいました。残念なのは、爪先端を切り離すところまで見たかったです。
有難うございます、今度は最後のパリンってのも入れます、よろしくおねがいします。
爪先は油圧で簡単に開けるぐらい軽い溶接なんですか？
そうです，表面を軽く仮付けしてるだけですので現場で開封の儀を執り行っていただきます。地域によっては神主による祝詞をあげる場合もございます
ワイヤーは何を使っているのですか？
参考までに是非おきかせください！
費用はいくら位掛かりますか？
上げるなら、部分補修ではなく全補修の動画上げれば良いのに
社長コメント有難うございます
社長の所のギッチリ行くやつ、今度取材させてくださいね