My long standaning misconceptions about the most, i feel diffcult topic of Fluid Mechanics got kicked out within just these 30 minutes.Thanku sir thanku
please solve this problem.a water jet is turned through an angle of 180 dgree by the device shown in figure.the fluid stream has a constant diameter of 2cm.if the magnitude of the restraining force is 500kpa,estimate the average water velocity of the incoming water jet.do you think this is a realistic set of flow condition?why or why not?
My long standaning misconceptions about the most, i feel diffcult topic of Fluid Mechanics got kicked out within just these 30 minutes.Thanku sir thanku
Crystal clear example thanks a lot
Only 1 comment 🤔🤔🤔
watch at 1.25x you will enjoy.
Can also watch it at 1.5*
I watch him at 1.5 or 1.75 😁
2x is normal, life is short
please solve this problem.a water jet is turned through an angle of 180 dgree by the device shown in figure.the fluid stream has a constant diameter of 2cm.if the magnitude of the restraining force is 500kpa,estimate the average water velocity of the incoming water jet.do you think this is a realistic set of flow condition?why or why not?
what is the normal volume of transportation passing through one houre , is there any table or a formual ?
Sir,Why can't we consider a moving control mass having mass of fixed entity?
it is difficult to measure parameter for moving control mass system. read about eulorian and lagrangian reference frame. Your doubt will be cleared.
Booooring