Jumper brake it’s on a Carrier while Trane has a terminal along the side of the fan center terminals in the Symbio 700 board,however,the older Trane equipment including new Relia tel would have a landing on the far right side where test screws are found. Fun times Good luck 👍🏽👍🏽
@@llchips7hi sir. If i want wire it to gas furnace what should I do. It already have 120 power. Should I wire NC and C to furnace with fan and R? Thanks
If the control is already powered and you are wiring a furnace to shut off, I would break red going to the thermostat by running it through C and NC. (6,16)
Run 24 through the 6 & 16 to cut power to the board and 8 & 18 to a 90-340 relay to cut the 120v to a motor if necessary. It is necessary to cut power to the motor when residential x-13 units used in commercial locations, because they don't shut down immediately.
Great Job simplifying something that intimidates so many younger techs in the industry!
Jumper brake it’s on a Carrier while Trane has a terminal along the side of the fan center terminals in the Symbio 700 board,however,the older Trane equipment including new Relia tel would have a landing on the far right side where test screws are found. Fun times Good luck 👍🏽👍🏽
Clear and concise. Thank you, sir.
Thank you so much
Ty
Thank you sir for make this informative video
thank you, it's very helpful
Great info!!!
Thanks. Good information.
I’m trying to install this in a air handler
What cables do I connect the green and the white to
You need to shut off the fan. It depends on what unit you have.
In this situation it would be best to kill R going to the thermostat. So if a fire alerts, it will shut off the unit
@@llchips7hi sir. If i want wire it to gas furnace what should I do. It already have 120 power. Should I wire NC and C to furnace with fan and R? Thanks
If the control is already powered and you are wiring a furnace to shut off, I would break red going to the thermostat by running it through C and NC. (6,16)
Hi Sir I am looking residential duct smoke detector wiring with 120V .
Best regards.
Run 24 through the 6 & 16 to cut power to the board and 8 & 18 to a 90-340 relay to cut the 120v to a motor if necessary. It is necessary to cut power to the motor when residential x-13 units used in commercial locations, because they don't shut down immediately.