SAMSON 3725 Positioner Calibration

In this short video we will show you how to reset a 3725 Positioner to factory default settings and perform an auto calibration.
Detailed step-by-step instructions can also be found by following the link
www.monarchinst...
We are not responsible for any damages that may be caused from what you learn from this video.

[@romaintiprez5905]

Vous avez sauvé la boîte merci

[@IsakAmunkete]

Easy and Well explained. Thank you. But, whenever i calibrate a SAMSON 3725 Positioner that has a solenoid valve between Positioner and Actuator, I get "ERR" on the display after calibration is done. HELP

[@priambodoajisupriyadi9421]

hello, thank you for explained this calibration. i have a question. if after P15 INIT calibration done and then the persentation do not show 0.0 % how to solve this problem.?

[@gildelrosario7710]

How to change the valve position from normally open to nornaly close?

[@marlonconsignado5589]

after doing the procedure after initializing an error occurred

[@marlonconsignado5589]

done.. i've check the position of the pin to the actuator must be in correct position

[@marlonconsignado5589]

also if error occurs try to disconnect the supply and restart again the process