Rear Drum Break, Rear Shoe Break, Replacement on a Skoda Fabia 2006 also for other makes & models.

Rear Drum Break, Rear Shoe Break, Replacement on a Skoda Fabia 2006 also for other makes & models.
Please note, after I uploaded this video I realised that I didn’t put a small spring on it on the each side, I had to put that afterwards. So make sure you put everything which comes with the kits. In total there should be 4 springs in this type of drum break, shoe break. The springs that I missed putting them on were the smallest of them all which goes on it at the end of the job. Thanks.

[@stewasb]

Quick question where do the 2 small star looking washers go please ???

[@twinshobbytwinshobby3863]

Super Video ! AWESOM JOB

[@Stoikor]

7:23 when you say to use a hand one, do you know to what torque it need to be?

[@AJsAuto-Fix]

Skoda Fabia 6Y2 wheel bearing Hub Tighten it to 175 nm torque. The wheel bearing unit must not tilt on the axle pin.

[@boombook6508]

​@@AJsAuto-Fix 70 Nm +30° not 175😅

[@gwizz9175]

It's something like 175nm. This is not shown well in this video
He is tightening and spinning the hub then backing it off and checking again. This is what you would do with old taper roller bearings where the nut seats the bearings and is secured with a split pin. On these they are simply done up tight.

[@robertward1367]

Good job on the brake pads, but the music 😢.

[@AJsAuto-Fix]

Thanks for the comment 🙏 and sorry about the music it was my first video and I am not very good with editing so hopefully, in the next videos will be quieter music! 😊👍

[@HenrikHvalpen]

Not a problem as long you dont talk while the music is going on. 🙂

[@_a_p_v_]

Что в 92м что в 2006 одининаково

[@KanouteKamal]

❤😂

[@علاءبيترو]

👍🏻👍🏻👍🏻👍🏻