Dear Usman. Thank you for sharing your all this information. According to your experience what would be ideal sized rotor for a 9 meter net head and 1000 liters/second. Greetings from Istanbul Turkey.
urpose? (b) In a laboratory experiment, water at 39.24 kPa is available to operate a model turbine at 415 rpm. What type of turbine will you choose if it is to have an output power of 30 kW? (c) A geometrically similar prototype turbine is required to be designed to produce 20 MW under a head of 16 m under dynamically similar conditions. At what speed will the prototype run? What should be the runner diameter ratio between the prototype and model? What will be the volumetric flowrate through the prototype assuming its efficiency is 90%
If you can teach yourself, you can read a translation of the original analysis by Googling "Banki Water Turbine". Also look for "Standardization of Cross Flow Turbine Design".
Please help me calculate flow rate and output Power of 3 inch tube well.
Thnx a lot for uploading this video..Really helpful
Dear Usman. Thank you for sharing your all this information. According to your experience what would be ideal sized rotor for a 9 meter net head and 1000 liters/second. Greetings from Istanbul Turkey.
Mashallah very nice
Great job done by you. i need your help..can you provide me the geometry of cross flow turbine.
Great work friend
Thank you dear for your feedback
urpose?
(b) In a laboratory experiment, water at 39.24 kPa is available to operate a model turbine at
415 rpm. What type of turbine will you choose if it is to have an output power of 30 kW?
(c) A geometrically similar prototype turbine is required to be designed to produce 20 MW
under a head of 16 m under dynamically similar conditions. At what speed will the
prototype run? What should be the runner diameter ratio between the prototype and model?
What will be the volumetric flowrate through the prototype assuming its efficiency is 90%
Very nice. What's the ideal rpm? Would it be better to choose lower D and haver larger width? Thank you!
Hello, have you found an answer to this question? Thank you!
where did you get 38 in calculating the speed turbine
Also thinking
38 is the rpm of model turbine, from which all these formula's and calculations are derived.
So with all youre numbers and more water, maybe 1000 lit/sec, a 300mm Runner need 1000mm with...?
👍
❤
hello, i need wind turbine power calculation in solidworks, is it possible ? if it possible how can i get that result ? thank you
Pls can help me with this question
what is the diameter of the pipe line sir?
Head and discharge is according to requirements but efficiency is very poor my cross flow turbine pl guide me
waalaikumsalam
Where did you get all of the formulas?
I learned these formulas from HYCON ( Asean Hydro Power Competence Centre Indonesia )
If you can teach yourself, you can read a translation of the original analysis by Googling "Banki Water Turbine". Also look for "Standardization of Cross Flow Turbine Design".
Wait, so your ideal turbine is 300mm in diameter, but only 78mm wide? Sounds more like an overshot waterwheel than a cross flow
I had the same value but i computed 90+ mm of the dia.width.
Bobo