Front Turn Signal Bulb Change - 2013 Ford C-Max (Minute Fix)
HTML-код
- Опубликовано: 5 окт 2024
- This series is showing steps to fix simple tasks in about a minute. (Note, will take longer than 1 minute to perform, this series just breaks down the steps in about 1 minute)
2013 Ford C-Max front turn signal bulb replacement (3457A)
Tools Needed:
3457A Replacement Light
T-30 Screwdriver
T-10 Screwdriver
10mm Socket
Thank you for showing all of the steps and being direct with what needs to be done.
Other videos show that you don't need to remove the wiring harness or remove the small T-10 screws. That whole sub-assembly can unscrew a quarter turn counterclockwise and the be removed backwards out of the headlight assembly. Just pull out the old bulb and press the new one in. Test it and then reassemble if everything works right.
You are the bomb! Took me more time to get the light out of the car than it did to change the light! Thank you.
Finally a video that worked
Keep up the great work
best explanation
Well Done! Short n sweet. Cool 😎
Hello i got a 2006 ford cmax I've been having problems with my turn signal it's been flashing too fast on one side and it's been interfering with other bulbs on the c max, but all the indicator bulbs are okay.
Excited that I’m not the only one who dropped the screws those little ones inside I’ve dropped into the bulb housing or whatever we call it! Nightmare how do I get a magnetic torques wrench?
Nice vid, made it look TOOO easy :)
I swear the engineers at Ford sat around for a whole week trying to come up with a tricky enough set up you were almost guaranteed to drop that tiny screw into the plastic void. Luckily a little careful spin job and it finallly found it's way to the very tip of the light housing and I did have a magnet on a stick to go fetch.
Last time it was the plastic threaded fasteners on the rear taillight. No retrieving that one without pulling the body panel. Cost me 2 trips to the Ford shop since they were fresh out.
Had planned on doing a 2fer. But after realizing I'd need a magnetic or magnetizable bit preferably actual scredriver as my bit holder was a little fat to be poking around n the plastic jungle.
Spent a little time wiping the dust off (apparently too long) when I got ready to head out and runs some errands and scrounge up a bit of magnetic kit, battery was dead. Think I drained it leaving back hatch open with the door light switch active. Hard to tell the dome light on when daylight is a shining shinning.
Probably about that time so while hunting magnetic kit got to remember to have em check the battery.
Nice video but please clean that car lol
replace turn signal ford c-max