That is a breakthrough in structure modeling. Keep going forward. One advise. When using the trim option it's helpful if you can see a box to select the side you want to cut, just like solidworks. This is special useful when you use the operation to multiple bodys. Also the 3D sketch must be more user friendly, that mean allowing you to draw easier in ortogonal way changing the plane with "tab" like in Autocad and also it should allow you to annotate everything in an ortogonal way letting you decide in which plane you want it to be again just like Autocad.
ruclips.net/video/8kI2TbPDHKQ/видео.html Интересует 53:37 минута. ПОДСКАЖИТЕ ПОЖАЛУЙСТА КАК ПОЛУЧИТЬ СПИСОК ВЫРЕЗОВ В ТАБЛИЧНОМ ВИДЕ... в Inventor. ДЛИНА -- УГОЛ1 -- УГОЛ2 как в видео ролике. (ответьте пожалуйста 797@15.com.ua) И еще подскажите почему Revit не правильно считает площадь стен?
Hi Atrem. I hope that this link will help you with your question on adding 'Cutdetails' to the BOM & Parts list: beinginventive.typepad.com/being-inventive/2012/06/frame-miter-cuts-in-bom-and-parts-list.html I'm afraid that I cannot answer your Revit question - perhaps you can post on the Autodesk Revit form? forums.autodesk.com/t5/revit-architecture-forum/bd-p/133
That is a breakthrough in structure modeling. Keep going forward. One advise. When using the trim option it's helpful if you can see a box to select the side you want to cut, just like solidworks. This is special useful when you use the operation to multiple bodys. Also the 3D sketch must be more user friendly, that mean allowing you to draw easier in ortogonal way changing the plane with "tab" like in Autocad and also it should allow you to annotate everything in an ortogonal way letting you decide in which plane you want it to be again just like Autocad.
You can draw ortho in 3d sketch. See here: ruclips.net/video/LkxBLZ1VAlA/видео.html
Great enhancement waited for this for a long time
Inventorが、やっと一般現場を見てくれた。
I would upgrade if there was permanent licenses. But will not go to subscription slavery.
Can you tab and slot ?
ruclips.net/video/8kI2TbPDHKQ/видео.html
Интересует 53:37 минута. ПОДСКАЖИТЕ ПОЖАЛУЙСТА КАК ПОЛУЧИТЬ СПИСОК ВЫРЕЗОВ В ТАБЛИЧНОМ ВИДЕ...
в Inventor.
ДЛИНА -- УГОЛ1 -- УГОЛ2
как в видео ролике. (ответьте пожалуйста 797@15.com.ua)
И еще подскажите почему Revit не правильно считает площадь стен?
Hi Atrem. I hope that this link will help you with your question on adding 'Cutdetails' to the BOM & Parts list:
beinginventive.typepad.com/being-inventive/2012/06/frame-miter-cuts-in-bom-and-parts-list.html
I'm afraid that I cannot answer your Revit question - perhaps you can post on the Autodesk Revit form?
forums.autodesk.com/t5/revit-architecture-forum/bd-p/133