SenseCAP T1000-E Meshtastic Tracker User Guide - Part 2: Status Indicators of the T1000-E

In this video, we pick up where the last one left off, providing a step-by-step demonstration of the various status indicators of the T1000-E. You'll learn how to power on, send and receive messages, charge, restart the device, enter DFU mode, update node/location information, toggle GPS on and off, and power off.
If you're new to Meshtastic or the T1000-E, this video is a great place to start. Check out the important timestamps below:
0:11--Power On
0:25--Working
0:34--Receive Message
1:29--Send Message
1:58--Charging
2:17--Restart
2:44--Enter DFU Mode
3:14--Double press the Button
3:28--Triple press the Button
3:40--Power Off
About the T1000-E:
SenseCAP Card Tracker T1000-E, the world's first IP65-rated Meshtastic device with built-in GPS and onboard sensors. With its nifty card size, it effortlessly fits in your pocket or attaches to your assets and works seamlessly with the Meshtastic LoRa mesh network, making it ideal for outdoor adventures and emergency response.
Some Useful Links:
1.Meshtastic:
meshtastic.org/
2.Learn more about T1000-E:
bit.ly/4cThbf1
3.Dive into our Wiki for more details:
wiki.seeedstud...

[@Androctonus84]

I tried several times to update the firmware, and it always would fail and exit DFU mode just as the new firmware installation was completing. Now the LED flashes extremely dimly about once every 2-3 seconds, the unit does not respond to any button pushes at all, and when connected to a computer it disconnects and then reconnects every time the LED flashes, so there is no way to even enter DFU mode any longer.